On a 2002 Electra glide with a new crank sensor, new coil, and plug wires, there is a faint to no spark to the rear cylinder. What would cause this issue? @
SOURCE: NO REAR SPARK
I had almost the same thing happen on my 03 sportster it was the ignition modual dont know what year yours is but 03s are bad about messing up harley said they fixed the problem on the replacements
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: adjust clutch cable
If you have a stock cable you need a 9/16 and a 1/2 in. wrench. about 1/2 way downn the cable there is a rubber boot. pull the rubber boot over the adjustment. Loosen the liock nut and adjust the cable so you have aprox 1/8 to 1/16 in. slack in the handle. Re tighten the lock nut and pull the rubber back over the adjustment.
SOURCE: air in rear shocks
Depending on your weight and if you carry a passenger as to the air pressure. I normally run about 14 but 24 if riding 2 up.
Recommended pressures:
up to 150 lbs- 0
each addition 25 rider pounds > 150 lbs add 1.0 lbs
each additional passenger pounds > 150 lbs add 1.5 lbs
each additional 10 lbs of laggage add 3.0 lbs
Max Pressure 35 psi
SOURCE: How do I change the front and rear brakes on a
Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.
222 views
Usually answered in minutes!
×