1996 zx6r I know this sounds ridiculouse but i can`t figure out how to take out my light bulb in the front and also i am looking for the rear fairings for my bike thanks

not much to go on here, but check the fuse. and the bulbs. does your dash lights illuminate or is it just the rear lights that are out? If none of the parking lights come on (front, rear,+dash) I would look at the headlight switch.

Hopefully you have figured this out. Its fairly simple to do. If your freezer if full you will need to empty enough that you can place your hand in and on the Plastic Light cover. Its in the center at the top of the freezer. This cover is removed by simply applying a little pressure to the right and left corner and pulling toward you and down. The light cover with very little pressure should mover and pull down. Once it begins to lower in the back just keep a hold of it and mover your hand toward the rear of the freezer and the front tabs will slide out.
After changing the light bulb, simply put the front two tabs of the front of the cover in first and snap back into place by pushing up. Takes about 3 minutes to change the light bulb. Good Luck!

Sounds like you lost the ground to the rear lights.

take outr the right brake light bulb and see if all the other lights start working. if so look at the bottom of the bulb and the socket it goes into and see if it looks the same as the left side. sound slike you have a bulb that has the 2 nips on the bottom out it melted. togher. or the bulb is just shortled

fast flashing usually indicates a burned bulb-but if your bulb good and no power at the light- can mean a wire is broken -does your winne have a trailer light hook up- start there and work back toward tail light looking for the break in the wires= good luck

air conditioning compressor clutch has failed Need new compressor assembly

another magic relay with fairy dust ,it does not have a relay for the side lights ,their is a fuse for each side of the side lights ,not front and rear so if both side lights on for the rear then its picking up a stray feed somewhere ,and if it is then this is a painstaking job to find and it might be quicker to rewire ,remember that both sides have seperate fuses so i would have expected it throw the front lights on as well so check the bulbs their as well

These are the part numbers from Kawasaki

Front brake pads, you will need 2 sets 43082-1142

The front rotors have been canceled, I will give you the part number 41080-1398-5C

Rear brake pads 43082-1171

The rear rear is also canceled part number 41080-1389-FB

Have look through these, one of them should help.
http://www.carlsalter.com/motorcycle-manuals.asp

if all the fuses are good check the wiring harness at the back check if there,s a power coming out on it, you can use a tester for the continuity of the power output, or you can also use a test bulb to check them all. if it not working then the problem is wiring harness locate the worn out wires... have a good day..