Question about 2005 Gilera Runner VX 125

2 Answers

Gilera runner sp50 - engine turns over but does not start

Gilera runner sp50 new cdi unit new spark plug and fuses ran ok for a few days. Engine cut out and engine management light on engine turns over but does not start any ideas?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a gilera dna 50 it was working perfect yesterday and all of a sudden its turning over it wants to start but wont ?

Posted on Mar 12, 2011

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 867 Answers

You went through the electric. system, now check fuel supply filter, tank, valve carb bowl for dirt

Posted on Aug 08, 2009

Testimonial: "Thanks there was a blockage"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Gilera runner 125 st 2008 cuts out by arcing


coil lead plug cap needs replacing , no shield to protect spark plug from getting wet due to weather/water splash. electrical spray lubricant requires from damp start problem

Dec 29, 2012 | 2008 Gilera Runner ST 125

1 Answer

My gilera st200 '08 always has trouble starting after a heavy rain. Most shops says that its the cdi, because at the meter there the red light doesn't go off after i turn on the ignition. But usually after...


First make sure you have ignition spark just remove the spark plug touch it on earth of bike and make a few turns of engine you should have on the edge of spark plug an ark. After you should check fuel pump if it drives fuel at carburator. Just take hose outer section and see if you have leak. At engine stop you should not have fuel.make few turns of engine.now you must have leak of fuel. If not replace the fuel pump . Be sure the vacume hose its not have been cut anywhere.

Nov 23, 2012 | Motorcycles

1 Answer

2005 Gilera Runner 50 PureJet won't start


Hi, Gtakriz and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
15. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
16. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
17. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
18. Faulty neutral, clutch lever, or kickstand safety switch.
19. Faulty fuel pump or fuse or relay.
20. A stuck bent or burnt valve.
21. Tilt sensor needs a reset.
22. Security system not disarming alarm needs a reset.
23. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Gilera Runner 50 Purejet Wont start and often stalls
Scooter Troubleshooting Scooter won start All about Scooters
http://www.cr-service.se/Piaggio%2050%20cc/Service%20manual/PIAGGIO_MSS_RUNNER%20PJ.pdf
Gilera RUNNER PUREJET 50 2005 Parts
Gilera Runner Wikipedia

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Jun 30, 2017 | 2005 Gilera Runner SP 50

1 Answer

Gilera runner sp50 on a 2003 nospark to the plug


put a new plug in it 1st...see if thats helps....if not check wiring to coil ..it maybe coil or cdi box that as gone..just have to work threw it....but start with new plug 1st

Feb 28, 2010 | 2005 Gilera Runner VX 125

1 Answer

Gilera runner sp 50 2003 wont start


Sounds like your oil/ fuel mixing valve may need to be replaced. New gaskets for it at least. Hopefullly your engine gaskets are ok, that's the first thing I thought of until I saw it was a 2 stroke.

Oct 03, 2009 | 2005 Gilera Runner VX 125

1 Answer

Gilera sp50 cuts out at speed, or while eccelerating


hi the bike has a vac fuel valve on the bottom of the tank or along the fuel line ther is two pipes one is vac one is fuel u need to draw a vac and see if fuel coms from the valve if this ok you need to clean the carb out make sure thers no dirt or water in the bottom of the carb

Jun 15, 2009 | 2005 Gilera Runner VX 125

1 Answer

Gilera runner stolen, changed barrel/immobiliser, no spark


You definitely need to change all with a kit of : ECU, engine main switch, seat lock and you will get in the kit 3 new keys, 2 black and 1 red.The black ones need to be programmed from the red one at a dealer's workshop.Then store the red some place safe.

May 27, 2009 | 2005 Gilera Nexus 500

3 Answers

Gilera runner stolen, changed barrel/immobiliser, no spark


There's a procedure to recode new keys, so the immobilizer let's you use the new key, if (and only if) you have the master key (red). Look at this PDF:
http://www.wotmeworry.org.uk/manuals/Gilera%20Nexus/Gilera%20Nexus%20500%20Mk1%20Workshop%20Manual.pdf

Look for "Setting the Circuit" in the PDF.
Good luck!

Mar 12, 2009 | 2005 Gilera Nexus 500

4 Answers

Repair CDI box Gilera Arizona 125/200, KK, KZ, RV....


no it has to be replaced it is sealed very well

Dec 26, 2008 | 2005 Gilera Runner VX 125

Not finding what you are looking for?
2005 Gilera Runner VX 125 Logo

Related Topics:

1,332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gilera Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5948 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

socbr

Level 1 Expert

50 Answers

Are you a Gilera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...