Https://www.marlinowners.com/forum/rimfires/42196-model-995-manual.html
https://www.gunpartscorp.com/gun-manufacturer/marlinglenfield/rifles-marlin/995
https://www.gunpartscorp.com/gun-manufacturer/marlinglenfield/rifles-marlin/995ss
https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=marlen+995+manual&_sacat=71134
https://www.gunbroker.com/All/search?Keywords=marlin%20995%20manual&Sort=13
https://www.facebook.com/MCARBOtriggers/videos/marlin-795-trigger-spring-kit-marlin-70-marlin-995-trigger/1113545898701761/
SOURCE: I have a LWK73AW w/m.
Hello, This
article shows step by step photo instructions on how to replace the
door boot seal of a common GE brand front load washing machine.
NO!.you did not need manual for this ,and at same time you might not get manual for fixing up the spring of the washer.
Carefully apply the below recommendation to fix up the problem carefully.
The washing machine in this example is the GE and the door boot seal is part# WH08x10036.
Instruction
Phillips head screw driver,small socket wrench,7mm socket,replacement door boot seal,lots and lots of patience
Completely remove control panel from front panel.
'Pop' off the tension spring being careful not to bend or break it.
On
GE models, pull the right-hand side of the seal tight to reveal the
inner tension ring holding the seal onto the inner part of the washer.
NOTE: you may have to remove the front panel to gain access
to the tension ring. If that is the case, remove the front panel by
removing the screws positioned at each corner (four screws total). On
some models you may have to first remove a lower-front panel to gain
SOURCE: Trigger adjustment on Marlin model 925
I have read a lot about the Marlin 925 trigger problems, and there are a few youtube videos that explain it step by step. It seems to change it to about 3 pounds. I hope this helps!
Here's a link to one of the videos:
http://www.youtube.com/watch?v=YciMN5bGPZo
282 views
Usually answered in minutes!
×