Location of fuse box 2019 softail @
SOURCE: 1998 harley davidson softail custom primary cover bolt pattern
Are u asking for the torque sequence for the outer primary cover ?
SOURCE: rear blinkers do not work. checked bulbs but
it is under your seat right in front of your rear fender long black box runs from left to right wedged between batterie and fender
SOURCE: REPLACINGTHE REAR TIRE ON A HARLEY DAVIDSON 2008 HERITAGE SOFTAIL
Down and dirty way - take it to the dealer and have them install a new tire....
The hard way: place bike on bike jack and remove rear wheel by removing the axle nut and drifting the axle out of the wheel. Derail the belt/chain and drop the wheel out of the brake caliper. Remove valve stem to deflate the tire. Get a set of tire spoons and a 12 pack of COLD brew cause working with tire spoons is no FUN! Pry the bead loose with one spoon and the work your way around the wheel prying the tire beed to the outside of the wheel. Repeat this process for the back side of the tire (in the same direction as the first side so the tire will come off the wheel. Reverse and repeat to install new tire.
By now you will be loading your wheel into the truck and heading to the HD shop. It just really isn't worth the hastle to save the $25 or so to have this job done.
Align wheel with new tire on it with the brake caliper so that you have one shoe on each side of the rotor (you may have to actually remove the caliper if your pads are thick. Install your belt drive/chain drive and then lift the wheel to insert the axle through the swing arm, the chain tensioner and wheel. Reverse
on the other side. Place axle nut on axle and torque to about 80lbs.
Good to go.
SOURCE: looking for the location of the fuse box on a
You got to love the soft tail ( I DO ) most of the time!!!! For most part any way the fuse box is under the seat right behind the battery and should have a cover on it Good Luck!
SOURCE: 2003 Harley-Davidson Softail Deuce FXSTDI
If your starter is spinning but the engine is not turning over, you over running clutch or Bendix is bad. On the Nippondenso style starter on the late bikes, this starter clutch is inside of the starter. You must pull the starter off and disassemble it to repair the starter. If you can do the job yourself, you can repair the starter and save some money. If you're going to have to pay a mechanic to do the work, simply replace the starter. Any money saved by repairing the starter in this case would be quickly depleted in labor cost.
Good Luck
Steve
6,599 views
Usually answered in minutes!
×