Question about Motorcycles

1 Answer

Ok (2007zzr6) spark check, fuel pump -pruning fuses check,, there isn’t any fuel passing through any injector I’ve cleaned and soaked an scratched my head for weeks ... I’m a shade tree mechanic ... I’ve put new plugs coils filter reset carbs pinched wires moved wires wile I’m trying to start it.. it is saying there is no fuel in the tank.. will the sensor tell the injectors not to pump it computer says it’s out of fuel .. all is perfect just no action on the squirters..... new ignition cut off as well.. I’m lost .. I have a 99 Zx6 ( my baby) zzr is nothing like that mistle that’s for sure..... on zzr there is only one set screw for each carb correct?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Motorcycles Master
  • 29,661 Answers

It has either carburettors or fuel injectors, not both! Which one ...........

Posted on Apr 19, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 99 Answers

SOURCE: Fuel Injector Wont Spray

check wires at throttle body. can use a 12 volt test light to check for current. if you have spark it is not the ign module. set meter for 12-20volts. should have 2 fuse boxes on this model, one behind right side of dash at floorboard

Posted on Nov 30, 2008

MrScary66613
  • 1990 Answers

SOURCE: 97 a4 will crank up, but won't start. maybe fuel?

It is the Fuel Pump and Possibly the Fuel Filter Both Causing this no Start Problem.

Posted on Jan 23, 2009

  • 332 Answers

SOURCE: Husqvarna 55 Chainsaw (1999) - Runs OK for 1 minute then stalls

I think your on the right track
Blowing compressed air through your tank vent
is great but it is way more air than the natural asperation
that the saw pulls on it own
I would replace the vent cap and also look for a pinched fuel line between the fuel tank and the carb

Posted on Apr 07, 2010

  • 211 Answers

SOURCE: husqvarna 51 died and wont restart

hi
if you have a good compression,a strong enough blue spark and carburetion for the fuel air mixture try priming the engine(put small amount of gas in the spark plug hole)then start the engine.If the engine runs only the gas you put inside the cilinder there is a carburetion problem to find and fix.
let me know regards savumihai71

Posted on Apr 29, 2010

  • 3567 Answers

SOURCE: 1980 Yamaha XS 400 Special First,

First, you need a good battery. The bike does have electronic ignition. Soak the carbs in denatured alcohol for two hours after removing the float bowls, then clean with spray cleaner. Spray into every large and small hole you can find. Remove the rubber diaphragm from the center of carb prior to cleaning. New diaphragms are $196 each. Check all fuses. Put in new spark plugs, NGK-BP7ES. Clean the air filter. Get a can of spray starter fluid and spray on the air filter. The rubber mounts for the carbs are likely to be a problem once it gets running. It looks like they are still available at Babbitt's, $53 each. If un-carburetored air can get into the joints it will lean the fuel mix and cause uncontrollable high idle.

Before you sink a lot of money into the bike, check for spark. If spark is present, coast the bike down a good sized hill without any spark plugs being installed. Put the bike in 3rd gear as you go downhill then let the clutch out to turn the engine over. Now ( using the clutch lever ), shift through all the gears then neutral. If the bike will not shift properly it likely has a bent shift fork. I can't find any forks avaiable. With a bad tranny I would put it back in the dirt floor building and find a newer bike. Here is a link to Babbitt's. Please rate my answer. Thanks.
www.babbittsonline.com/pages/parts/viewbybrand/default.aspx

Posted on Aug 13, 2010

Testimonial: "Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spark plugs getting wet from fuel, compression ok, not starting, timing ok, spark ok, new spark plugs, changed fuel pump in tank,


Check fuel pressure regulator. The actual pressure with a gauge the clean injectors. I'd double check the timing. It also can be the throttle body. Only so many fuel problems the take a good look at the distributor. Small crack or bad wire gives off spark but might not be enough small 4 cylinder for their pecission motors need to be precise check fuses and main busses those are easy and cheap fixes

Jan 01, 2015 | Mitsubishi Cars & Trucks

1 Answer

No power to fuel injectors, ignition fuse, or fuel pump


Year, make, model, and engine size?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Apr 05, 2013 | Cars & Trucks

2 Answers

Installed new fuel pump and cleaned all 6 fuel injectors but it won't start


Have you checked fuel pressure at the rail with a gauge yet ?
Are you getting spark to the plugs ? Have you tried spraying starting fluid into the intake to make sure it is a fuel problem ?

Dec 15, 2012 | 2006 Toyota 4Runner

2 Answers

95 Park Avenue Ultra dies for no reason I can find, I've replaced the crank sensor, cam ssensor, spark module, fuel filter, I've had the injectors tested, fuel pump tested, plugs & wires t


As you have probably figured out by now, you will have to treat it as a no start and troubleshoot it when it fails to start. Until you figure out if you are loosing spark or fuel to the injectors when the engine dies you have no direction to go in.

Aug 20, 2012 | Buick Cars & Trucks

1 Answer

My 93 prelude won't start i change the fuel pump i check my fuses so what now i need help


You will have to see if your getting spark and fuel. If your getting both it should be starting either timing or injector pulse isn't working maybe. If your not getting spark, you will need to check your ignition system. If your still not getting fuel then you have a relay or maybe a computer problem. This isn't exact but a short list of what to check so you can reply with more information.

Aug 05, 2011 | 1993 Honda Prelude

1 Answer

I have a 1996 Saturn Sl2. It ran out of gas one day and sat on the side of the road for a few days. Well, I finally got it towed home, and changed the fuel filter. The fuel pump is good. But, it is smoking...


Here are your possible problems. 1)Leaking injectors(Rare), Leaking Fuel Pressure Regulator(Common) Bad Engine Temp Sensor. (Common), Here is what i would check. Find the Regulator and pull off vacuum line, (located on fuel rail near injectors) check if there is fuel present in line. If yes replace regulator. Check temp sender with a scanner your looking for a reading in the (-) or below 140deg F, when car is first started and smoke present if yes replace engine temp sender for computer(not sender for guage!) IF both those pass inspection replace injectors(Not common problem)

May 20, 2011 | 1996 Saturn SL

1 Answer

Replaced the Fuel Delevery System/Pump and the in-line fuel filter on my 93 GMC Vandura Van 2500. Van turnes over; however, no fuel in getting to the engine. I have checked the Fuel Pump...


install a fuel pump guage and check pressure at key on and start, it should hardly vary, it the pressure is constant check the injector signal with a noid light, while you are at it check spark(no spark no injector signal) you won't find a relay fuse

May 07, 2011 | GMC Vandura Cars & Trucks

1 Answer

1996 dodge neon has gas but no spark i change the ignition coil but still wont start what could it be is it the crank sensor or fuse


If there isn’t a spark then check Electrical system, or check the gas system from the injectors up to fuel pump. Do not forget the fuel filter ….

Aug 23, 2010 | Dodge Neon Cars & Trucks

2 Answers

Have a misfire on cylinder 3


Hello
Here is what to check let me know if you need help checking this out
most common misfire causes on the cars I've worked on have been:
  1. Spark plugs
  2. Spark plug wires
  3. Ignition coil
  4. Fuel injector
  5. Wiring to fuel injector
  6. Timing Belt
  7. Vacuum leak or stuck open EGR
  8. Contaminated fuel or bad fuel pump
  9. Weak compression
  10. Blown head gasket

Jul 14, 2010 | 1998 Dodge Durango

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5860 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...