I have to wiggle my ignition switch several times before it works, i have a travel lx go-go scooter. Any ideas what to check?

SOURCE: 96 accord - turn key, nothing happens. bad ignition switch? help!

Could be.

Also the jiggling thing could be a coincidence. :0)

Tell me this.... when you turn the key, do you hear a CLICK?? If so your starter is probably bad.

:0)

SOURCE: I have a ctm scooter the battries are charged

I would say the throttle pot is slightly out of neutral allowing the scooter to travel slightly when turned on. Try moving the throttle lever slightly in the opposite direction to which the scooter is travelling (i.e. if the scooter moves forward when turned on, press the lever to go backwards, but only a small amount). If the scooter stops and you hear a clicking noise from the back of the scooter (this would be the brake clicking on) then that would be your problem. Would just need a small adjustment but best left to a dealer as it has to be sopt on! Sometimes scooters will not work if the throttle is slightly out but if its only a very small amount out of neutral, it might sometimes work in the manner you have suggested. We have come accross this fault on a few occasions. Hope this helps...

SOURCE: When I stop the scooter after travelling a short

Hi. Yes, most, but not all machines have a "sleep" mode. More for safety than any other reason. Neil .

SOURCE: I have a ctm scooter the battries are charged

The joystick will display a sequence of flash codes. Count them and find the count here: This could be several issues, But the flash code will tell you for sure.

1. Stall Timeout, Joystic out of neutral
2. Battery Voltage too over 32VDC hi or too low under 17VDC
3. Left motor Fault
4. Right Motor Fault
5. Left Brake Motor fault
6. Right Brak Motor fault
7. Shark Control Module Faul
8. Power Module Faul
9.Shark Module Faul

Contact me Direct 909-590-1388 x115 CTM HOMECARE OFFICE