Question about kawasaki Motorcycles

2 Answers

Petrol is pouring out of a drain hole in the carburetor on my kawasaki tf22, when it is running?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Blocked jet in carb

Posted on Apr 20, 2019

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • kawasaki Master
  • 24,394 Answers

Float level is not right

Posted on Apr 04, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Richie_asg1
  • 1036 Answers

SOURCE: kenmore refrig water runs from freezer drain

Hi,
It sounds like they saved a bit of cash on this model by putting a T in the drain pipes of both - thereby saving 2 feet of pipe.

If the lower part of the drain pipe is blocked - it will flow into the lower section as you say.

You need to clear the lower drain pipe. Using vehicle wire (flexible PVC covered wire) will clear the blockage (turn off unit first). Then use an anti-fungal cleaner to remove the remains of the block.
You may even need to do this from the other end of the pipe that exits to a dish on top of the compressor.

Posted on Aug 30, 2009

jyackle5
  • 8197 Answers

SOURCE: We have a Kawasaki Hedge Trimmer TF22. I need to

The oil ratio for the trimmer is 50 to 1.

Good luck and please rate 4 thumbs uf for the free answer

Posted on Jun 26, 2010

Testimonial: "Thank you very much for your help. It was given to us by a friend but no manual"

frankgilbert
  • 613 Answers

SOURCE: 1984 f-150 inline 6, 1

I need to ask a few questions and please do not think I am insulting you.
How much gas is in tank?
Is the gas good gas and not with water in it? Can you take any gas from the hose into a clear container and wait a minute and see if separation occurs?
Can you see gas squirt into carburetor when you pull on the accelerator cable or push the lever in on the carb? If you can see it..it is going into the intake and .most likely bad gas.
Lastly and another problem area is the fuel jet inside the carb is stuck or has an obstruction such as goo from bad gas?
This gives you some ideas on what to look for and thanks for using FixYa.

Posted on Jan 24, 2011

  • 185 Answers

SOURCE: My Coleman 5000 generator in

It sounds like your carb needs to be taken apart and cleaned out. The gasoline in the carb sounds like it has varnished and blocked the passages in the carb. I would try some carb cleaner, if you are comfortable in taking apart the carb, you can use the spray cleaner to open the passages. You might have to soak the carb a bit as well.

Posted on Mar 10, 2011

  • 2239 Answers

SOURCE: Petrol not pumping through to

Fuel starvation, replace the fuel filter in the tank on the end of the fuel hose, check the fuel hoses for leaks and cracks, replace if needed.

Posted on Aug 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i get the fuel tank for my hedge tremmer kawasaki tf22


from the manufacturer spares , from any mower repair shop , from any kawasaki service agent

Apr 20, 2017 | kawasaki Garden

1 Answer

I have stihlsaw ts350super i have fitted new piston and cylinder it will run for a short time only when i pour petrol in plug hole when running sounds good


If the chainsaw engine stops after a few seconds, the carburetor might be clogged or have a restriction. If old fuel was left in the chainsaw for a long time some of the volatile ingredients may have evaporated, leaving a thicker, stickier product that is more like varnish. This sticky fuel can clog up the small jets and ports in the carburetor causing the engine to only run for a few seconds. Clean the carburetor with carburetor cleaner. If that isn't effective, rebuild or replace the entire carburetor

Nov 27, 2014 | Cars & Trucks

1 Answer

I have stihl saw stone cutter i have rebuilt it with new cylinder and piston it will only run for short time when i pour petrol in plug hole it sound good when running


This indicates that you have carburetor or intake setup problems. If the saw had sat a long time then most likely your going need clean and rebuild it. Please note that cleaning these with carburetor cleaner and especially the drip can destroy the carburetor. It is best to use an ultrasonic cleaner on these carburetors.

Also check intake gaskets placement as you may have installed either out place or backwards.

Nov 27, 2014 | Stihl Garden

1 Answer

Kawasaki zrx1100 sump full of petrol why


Your carburetor (or carburetors) is in desperate need of a rebuild.

Jul 30, 2014 | 1999 kawasaki ZRX 1100

1 Answer

Kawasaki fc420v-fuel leaking from carb.


I have the exact same problem on a JD175 with the same engine--gas spewing out of a hole above where the fuel line connects on the back of the carburetor housing. There's a similar hole on the opposite (front) side of the housing. I'm told there are factory-installed plugs in both holes and the whole carburetor assemble will need to be replaced. Please post if you discover something different!

Apr 07, 2013 | Motorcycles

1 Answer

My scooter wont start


Drain the petrol out of the carburetor and tank. leave the bleed screw open on the carb and let fresh petrol run through for a few seconds... try starting again and use some starting fluid. If it runs at all (even for a few seconds) then you know the carburetor needs cleaning. If it runs like **** ride it around for a bit, keeping the revs up high. If that doesnt work take the Carburetor to a mechanic to be cleaned or do it yourself.

Sep 09, 2012 | Motorcycles

1 Answer

1996 Kawasaki Ninja ZX-11 carburetor leaking


Hi, Anonymous and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
8. Damaged petcock diaphragm allowing fuel to flow through the vacuum line into the combustion chamber.
9. Contaminated fuel tank.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Carburetor leaking fuel help KawiForums Kawasaki Motorcycle Forums
zzr 1100 air cleaner removal and carb petrol leak
Kawasaki Ninja ZX 11 Service Manual
OEM Parts for Kawasaki
1996 Kawasaki Ninja ZX 11 Owner Manual

Mar 28, 2012 | kawasaki Motorcycles

3 Answers

I need to drain my Honda Activa petrol tank as I need to transport it to Bangalore. How do I do this.


Shut off valve at the bottom of tank. remove fuel line from carburetor and point it into an approved fuel container. Open fuel valve and drain tank. If you have a reserve setting on your valve, turn it to that to get all the fuel out. Then, look the the bowl of your carburetor. At the bottom there is a small drain line. Above that drain line is a slotted screw. Point that drain line into a container and turn the screw left to drain the fuel out of the carburetor bowl. Retighten the screw after it drains. Place your fuel tank valve to off.

Nov 23, 2010 | 2005 Honda Activa

2 Answers

We have a Kawasaki Hedge Trimmer TF22. I need to know the ratio of gasoline and oil to put in it


The oil ratio for the trimmer is 50 to 1.

Good luck and please rate 4 thumbs uf for the free answer

Jun 26, 2010 | kawasaki Garden

1 Answer

How to or what tool I use to drain a Kawasaki Eliminator 125 CC carburetor?


there should be a small screw at the base of the carb bowl. under or to the side of the screw will be a nipple or hose, this is your drain hole. the screw may be a smal allen head or flat head bolt.

Mar 21, 2010 | 2008 kawasaki Eliminator 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5856 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

richard libby

Level 2 Expert

202 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...