Motorcycles Logo

Related Topics:

Gabe perkins Posted on Jan 23, 2019
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

I have a Yamaha raptor 700 that ran out of gas while I was doing a manual now I can’t get it to start i’ve put more gas in it I’ve check for spark but I still can’t get it to turn over help

1 Answer

zoe dee honea

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Expert 45 Answers
  • Posted on Jan 23, 2019
zoe dee honea
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Jul 24, 2013
Answers
45
Questions
2
Helped
18385
Points
141

You may need to prime the fuel lines or spray starter fluid into combustion chamber then try starting it. Good luck.

5 Related Answers

Anonymous

  • 32 Answers
  • Posted on May 31, 2008

SOURCE: 97 honda civic wont start.

If the car has over 100,000 miles on it, you may need to replace the distributer. I don't think the bad gas caused this issue I think it may just be a coincdence. But if you already changed the plugs, wires, distributor cap, and rotor, I would definetly check the distributor.

Ad

Anonymous

  • 1 Answer
  • Posted on Aug 29, 2008

SOURCE: replacing rear brake pads on a 2006 yamaha raptor 700

open bleeding nipple slightly insert anything flat and push back piston ,lock bleeding nipple put pads in and pump brakes

Anonymous

  • 1 Answer
  • Posted on Feb 12, 2009

SOURCE: 2001 raptor cabs not getting gas

Ihad this problem, I let gas sit in the motorcyle over winter. Bad mistake,The whole carb needs cleaned. I took my carb to the yamaha shop and they charged me $146.00 to fix it. Or you can take the jets and needle seat out and soak it in carb cleaner for a couple of days. Yamaha soak the carb in carb cleaner for 2 or 3 days, remember to remove any plastic, gaskets, rubber.

jim

  • 10 Answers
  • Posted on May 28, 2009

SOURCE: Help w 1994 chevrolet truck

disconnect the batt. is your fuel pump running check fuse listen for it

Anonymous

  • 142 Answers
  • Posted on Jun 02, 2009

SOURCE: Yamaha 2001 Raptor 660, need to clean my carb

Drain and replace the gas with fresh.
Remove the air cleaner and spray carb cleaner into the inlet. Work your throttle a little then put everything back together and try to start it.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 1985 Yamaha maxim that hasn't been ran

Spray starter into the carb intake with no choke, if she runs for a few seconds then you know its fuel starvation
clean jets & airways & blow through with compressed air
0helpful
1answer

I have a 2001 660 Raptor. Thought it had dead gas in it and hadnt been started in about 2 years. Drained the gas, put in fresh gas and it sputtered and backfired. rebuilt the carburator and does the...

Hows the oil in it? also i would suggest spark plug sitting that long with gas inside the tank isnt good for any bike but it was good to drain. If its not spark plug check all basic engine problems than maby bring to mechanic it may need rebuilt.
1helpful
1answer

My 2003 660 raptor will not start

You have probably checked spark by now. if you haven't do so. also check your ignition box.
1helpful
1answer

Raptor 700 has fuel compression and spark but wont start?

i am having the same problem with my 660r if i can figure it out on mine i will let you know for yours but if any one else can help us both that would be cool 2 lol
0helpful
1answer

Same problem o6 Raptor 80 will not start

Get a compression tester to see if she has plenty of compression or take spark plug out ,put your finger over plug hole and turn engine over. you should feel a pressure forcing your finger away.
2helpful
2answers

Yamaha 2001 Raptor 660, need to clean my carb

Drain and replace the gas with fresh.
Remove the air cleaner and spray carb cleaner into the inlet. Work your throttle a little then put everything back together and try to start it.
Not finding what you are looking for?

246 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...