Changing rear bearings Kawasaki bayou 300 4*4
This video's may help you with you're problem. \/
Also for pulling the bearing out of the axle I recommend a bearing puller set you can buy cheep online and rent a slide hammer from most auto shop's another video about the tool. \/
and use a socket that has the same outer diameter as the bearing to install.
If the rear axle is not the same please disregard this
but the video may still give you some insight as of whats ahead.
SOURCE: kawasaki 300 bayou won't rev up.
No guarantees but try this. Pull the slide from the throat of the carb. Now move the clip on the jet needle down one notch. This will richen the low end mix. Two notches may be needed but do one notch at the start.
SOURCE: How to change rear wheel bearing on Kawasaki 300 bayou
Don't mean to cop out on ya, BUT the best $$$ you'll ever spend on your ride is a service manual from say amazon.com for example. It'll step you right through it, complete with tips and little nuances particular to your bike. You'll be thankful you bought it!!!
507 views
Usually answered in minutes!
×