Hi i have 2005 kdx 50 2005 mod has spark but will not start

My scooter has no spark how to fix. gy6 chinese ... - YouTube

? 2:29
https://www.youtube.com/watch?v=UU4S0Ov9q4c
Aug 24, 2012 - Uploaded by Rolling Wrench
Purchase our "NO SPARK KIT" click the link below: ... My scooter has no spark how to fix. gy6 chinese scooter 139qmb qmb13950cc 150cc.

Author Topic: people 50 2 stroke no spark CDI?? - KymcoForum.com

www.kymcoforum.com > Scooters - 50cc > People 50
Aug 5, 2012 - 7 posts - ‎4 authors I have a 2001 people 50 2 stroke that only has 125 original miles. ... I ordered a CDI and coil from monster parts and it still would not start . Author Topic: (Almost) no spark / engine not ...
15 posts
Aug 15, 2011
Kymco People 50 - Not A Morning Scooter ...
15 posts
Sep 28, 2010
Author Topic: 2005 People 50 2T Mods ...
15 posts
Jul 27, 2010
Kymco People 50 - KymcoForum.com
10 posts
Nov 15, 2008
More results from www.kymcoforum.com

Have a 2005 Kawasaki contour shaft drive. When the bike is off or on in neutral when I'm rolling it back the cluch is clicking. Is this that the cluch is out of adjustment? If so how do you adjust a shaft drive? Thanks

THIS QUESTION DONT MAKE SENSE SINCE THREES ONLY ONE SPARK PLUG ON A KDX 125..BUT A WEAK SPARK COULD MEAN ANYTHING IN THE ELECTRICAL SYSTEM..CDI,STATER,WIRING LOOM,CORRODED CONNECTION SOMEWHERE...ITS HARD TO SAY WITHOUT SEEING IT..AND SYSTEMATICALLY TESTING ITS COMPONENTS..

try ebay?

It may need rebuilt maby it does not have enough compression to turn over i would suggest getting a compression test done at a local bike shop. If thats the case it most likely needs rebuilt.

unfortunately apart from removing the lights you wont turn it into a MX bike, new expantion chamber,porting and suspension mods are all quite expensive, just try and learn as much as you can as it is(minus lights)

The clutch in your bike is a wet clutch. There is a lot of hyrdostatic friction even when the clutch is released completely. I think a large factor is the type, age and condition of oil. Perhaps something as simple as an oil change would help.

try a new plug, then if it doesn't work get a new spark plug cap... the thing that screws on to the ignition lead

try cleaning the spark plug whole and wire and make shere there is plenty of gass in it.

The side stand kill switch can go bad and do this. Check the switch with an Ohm meter. Also, check the wiring harness connections. Fix any loose connections. Check the handlebar kill switch. It can go bad also.

Please rate this answer. Thanks hd87lovetori!