SOURCE: I want to chang the horn in my kawasiki ninja zx6r
the horn is only held on by 1 bolt,undo this and remove the 2 wires then just reverse these steps to refit
SOURCE: 2009 kawasaki klx 250 - need correct procedure for
•Using the jack under the frame, and stabilize the motorcycle.
Special Tools - Jack: 57001–1238
•Loosen the left and right axle clamp bolts •Unscrew the axle nut . •Place a stand under the engine to raise the front wheel
off the ground. •Remove the axle, and pull out the wheel. Take off the
collars and caps from each side of the front hub.
CAUTION
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so the disc does not
touch the ground.
•Insert a wood wedge between the disc brake pads this
prevents them from being moved out of their proper position,
should the brake lever be squeezed accidentally.
Front Wheel Installation •Apply grease to the seals. •Fit the projection on the cap to the groove on the collar. •Install the caps , collars on the left (longer collar)
and right (shorter collar ) side of the hub. •Insert the axle from right side. •Unbolt the right and left axle clamp bolts temporally. •Tighten the axle nuts •Tighten the left axle clamp bolts.
Torque - Front Axle: 78 N·m (8.0 kgf·m, 58 ft·lb)
Left Axle Clamp Bolts: 20 N·m (2.0 kgf·m, 14.5
ft·lb)
NOTE
○Tighten the two clamp bolts alternately two times to ensure
even tightening torque.
SOURCE: wiring diagram 2001 zx6r
Try this manual, it should cover all your needs. Are you sure you have the correct rating fuse in the box, the manual will solve the problem any way. Good luck:
http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%2000-02%20Service%20manual.pdf
SOURCE: valve adjusting
You need to take the #1 plug out and make sure the piston is at top dead center. Then make sure that the alignment mark on the timing rotor is pointing at the mark on the engine casing. You will want the cams positioned so that the heels of the lobes are down toward the cam followers. The lobes themselves will kind of point up and away from the cylinder head. Also there should be marks on the cams they need to be level with the top of the cylinder head. You will measure 4 valves on 1 of the cylinders and 2 valves each on 2 others. Then rotate 1 full turn and measure the other four. In any case make sure the heel is down towards the follower and the crankshaft timing mark on the timing rotor is lined up with the mark on the engine case..
SOURCE: Hi I need the paint code, for my kawasaki zx6r
Hi.
The factory did not made public the bike paint color codes.There are resources from third party sellers available.
Please use any of the resources below to identify the paint codes of your bike.
Check first with Color Rite. They list all Kawasaki factory paint codes:
Find your color code at Color Rite - Kawasaki Motorcycle Paint
Below more resources:
Full list of Kawasaki codes. From Japart-Nl.
Kawasaki codes explained.
Regards.
Ginko
71 views
Usually answered in minutes!
×