Where is the air bleed valve on a gilera nexus 250 cooling system?

Stop using until you find out as if it is a oil pressure problem
Wear and a seized engine can happen not the sort of the thing you want to happen

look at your top radiator hose is there a small bleed valve at the top of the thermostat housing when the upper hose attaches to? If so loosen the bleed valve and allow the cooling system to purge the air out of the system you can tell when the air is out of the system when a steady stream of coolant starts to flow out of the bleed valve, if there is no bleed valve take the top radiator hose off of the engine side and allow the cooling system to purge the air out through the top of the engine that way

Theres a strong possibility being you just changed the coolant a few weeks ago that theres air in the cooling system not allowing the coolant to cirrculate properly, look at your top radiator hose is theres a small bleed valve at the top of the thermostat housing when the upper hose attactes to? If so loosen the bleed valve and allow the cooling system to purge the air out of the system you can tell when the air is out of the system when a steady stream of coolant starts to flow out of the bleed valve, if theres no bleed valve take the top radiator hose off of the engine side and allow the cooling system to purge the air out through the top of the engine that way, but it definatly sounds like theres air in the system not allowing for the cooling system to cool properly...

Im also looking for gilera rc parts u could try this website http://www.hahne-power.de/gilera.htm

no absolutely not. you may have tight spaces to work in but do not remove the engine.

http://www.manualz.info/


try here for manuals


hope this helps