I have a 2009 Kawasaki 750 and it’s sucking up to you oil And I’m finding oil in the air filter

SOURCE: How to I replace the oil filter on a 2009 Toyota Camry V6 engine?

Under the engine in the front you will see an aluminum cover.There is a square hole that fits a 3/8 ratchet remove this first.The new filter comes with a drain adapter that snaps in the hole under the cover.This lets the oil in the housing drain.Then take a oil filter cup wrench or a big channel lock to twist of the larger portion.Then change the filter and o-ring and reinstall.Make sure the o-ring on the square drive cover is there also

SOURCE: oil light comes on,od a 2004 kawasaki 750 vulcan.

you must have a fault with the sensor buddy replace this or the connections are not in correctly or is this the oil pressure light

SOURCE: find oilfilter location on kawasaki zzr 1100

Bottom of motor there is about a 31/2" round cover with a bolt through the middle thats the filter you may have to remove the exhaust to get to it on your bike

SOURCE: how to change oil on a 2003 Kawasaki Vulcan 750

Firstly run your engine till you reach its normal running temp .The engine drain plug will be found under neath the engine normally at the lowest part .Warm oil drains out of the engine much more quickly that cold oil ..when all the oil stops dripping then remove the oil filter ,make sure that the sealing ring is removed ,take care the oil in the filter will be very hot .replace with your new filter make sure you do not cross thread the oil filter unit and any seals have been fitted . Refit your drain plug and fill up to the required level . start engine ,your oil level will drop because the oil filter will fill up and the new oil will be pumped around the engine. make sure that the engine level is topped up when all the oil has reached all the parts of the engine .Do not over fill the engine as this will cause unwanted pressure .and oil leaks .Remember to replace the oil filler cap and that its tight .

SOURCE: how do i change oil filter on kawasaki 750 zepher

Underneath the sump pan there should be a 17mm bolt head in the middle of a circular plate undo this and lower it down but watch you dont lose any of the bits n pieces and your filter will drop down with this