I have a 2006 Harley Davidson dyna street bob that won’t start. Turn the key on then turn to run position don’t hear that whining noise from the fuel pump and then hit the start button nothing happen all light are good . Need help please

SOURCE: No Start when key is turned

Ma wish to check starter it could be bad or have loose wires on it. There may be a starter relay in the fuse box under the hood it may also be bad.

SOURCE: Problem starting 2002 Road King

Buy a new battery.

SOURCE: Are there any main fuses on a 2001 plymouth neon

Have you checked the starter solenoid. Your battery + cable connects to this then + cable runs from it to your starter. You also have an ignition switch wire connected to this. Just follow your cable from the battery and it will lead you right to the part. Some times these will break inside or the contacts go bad inside and therefore you will not get power to start the engine, but you will have power to turn on lights or whatever other accessories.The part is about $15

SOURCE: My 07 street glide won't start.when i turn the key

Turn the handlebars to the left and lock them with the key. Once locked, unlock and try to restart, this resets the alarm on my 2008 FLHX.

SOURCE: Car will turn over but won't start. Through the

No noise from fuel pump when you turn over the car .First thing get voltage at fuel pump relay checked, is there 12 volt to the relay.If no, then problem is again the relay.--------- To reconfirm the problem, try other test, that is remove the relay and by pass the relay terminals with a jumper wire .Then with 12 volt external battery give power to fuel pump connector and see, if the fuel pump starts, then its clear that fuel pump relay is faulty.----------- Also other problem can be fuel pump inertia switch.If the inertia switch is faulty then also fuel pump will not start.-------- The fuel pump relay on a 1995 Ford Explorer is in the power distribution
box, in the engine compartment, driver's side near the firewall.----------
The fuel pump inertia switch is in the right front passenger area
it is below the dash but above the carpet in the right hand corner.--------
Its a push button type inertia switch.
--------
Fuel Pump Activation
When ignition switch is turned to START position, PCM operates fuel pump relay to provide fuel for starting engine. PCM senses engine speed and shuts off fuel pump by opening ground circuit to fuel pump relay when engine stops or engine speed drops to less than 120 RPM. When ignition switch is in ON position, EEC power relay is energized (contacts closed). Power is provided to fuel pump relay and timer in PCM. Fuel pump receives power through fuel pump relay contacts.
Inertia Fuel Shutoff (IFS) Switch
All models use an electrical interrupt switch in fuel system. During a collision or vehicle rollover, electrical contacts within inertia switch open, shutting off fuel supply to electric fuel pump. Fuel supply is interrupted even when engine is running.
A reset button is located on switch assembly. If electrical circuit trips, vehicle will not restart until switch is reset. Fuel system should be inspected before resetting switch.
IFS switch is located under instrument panel, near right side of transmission hump. ----------- If the fuel pump relay, the inertia switch and fuel pump all checked ok, and fuel pump is working with direct 12 volt source to fuel pump.Then problem relates to computer.The computer (power control module, PCM) is faulty and has to be replaced.--------- This will help.Thanks.Helpmech.

Testimonial: "Thanks. That was the best answer yet.I didn't want to hear that the PCM might need to be replaced but the car has served it's purpose through the year"