SOURCE: how to set electric clock on 2003 yamaha roadstar silverado
hold both buttons down @ same x. they will start to blink. hit left button once and hour will blink. use right one to go up. repeat for mins.
SOURCE: Paint codes for 2005 Yamaha Roadstar Black & white
http://www.colorrite.com/matrix-colors.cfm?CFID=1620536&CFTOKEN=74145802
Go here my friend.
Bob
SOURCE: How do you check the oil in a 2003 yamaha roadstar
all bike are to be checked in the upright position! then find out how much the bike takes from your manual if you dont have a manual ...do the following ..when you just change oil and not filter you will be adding less oil,"almost" all bikes take @ 3 quarts oil minimum, so what i do to be safe!! is always after draining is put in two quarts no problem, but with the third bottle i only pour in half.. drop oil cap back on and start the bike and let it run for a minute, the turn it back off, then check oil level, if it doesn't register anything on the stick or sight glass then your o.k. to add the rest. now take a reading, and only fill to almost full, i always under fill my bikes, because over filling will cause damage to internal bearing by the air bubbles from the splashing of the crank in the oil pan. Same as cars.
If you found this helpful can i get a rating?
Thanks
SOURCE: yamaha roadstar 1600 yr.2000 digital
The first thing you can do is check the fuses, the fuse box is either under the seat or behind the cover on the left side as you are sitting on the bike, if all is good then remove the speedo cluster and connect it to your battery directly, Here is the procedure from the manual CHECKING THE LEDs The following procedure applies to all of the LEDs. 1. Check: LED (for proper operation) a. Disconnect the meter assembly coupler (meter assembly side). b. Connect two jumper leads 1 from the battery terminals to the respective coupler terminals as shown. WAWRNARINNGING • A wire that is used as a jumper lead must have at least the same capacity of the battery lead, otherwise the jumper lead may burn. • This check is likely to produce sparks, therefore make sure that no flammable gas or fluid is in the vicinity. c. When the jumper leads are connected to the terminals the respective LED should illuminate. Does not light ® Replace the meter assembly. This will tell you if it is the meter, If the meter is good then you will need to follow the wires connected to it till you find the problem. I hope this is a big help to you.
7
SOURCE: What oil do i run in my yamaha roadstar silverado
Any oil that is JASO MA certified motorcycle oil. 10w-40 for cold climate. 20w-50 for warm climate/touring. Car oils use different additives. Do not use any oil that says Energy Conserving on the label . It will shorten the life of your wet clutch and transmission gears. If you use Synthetic oils, they will help your bike run cooler and shift easier.
373 views
Usually answered in minutes!
×