2009 Nissan versa engine starts wont keep running problem started car would drive around 5 miles quit let set a wile go again for a wile then quit agan now car srarts up but will not run

How many miles on engine? Broken timing belt? Spark to plugs? Correct fuel pressure?

You have to check petrol filter ,
if not , there is high sound when you accelerate the car

run the fault codes first
it could be a blocked cat converter of fuel pressure problem

Try changing or switching out the distributor. Most likely getting hot and shuts down. Does it crank but no start whenever it stops? May only start when it cools down again.

Probably way overdue for a service, take it to a properly qualified and licensed mechanic you know and trust.

dont go to mr transmission. I have had to go back 15 times then i finnaly sold the car because they recked it. sounds like a speedo sensor or the sterio installer cut the wrong wire

Have you checked your "knock sensor" or cam sensor? It tracks cam and or crank movement for timing.

Hi Kathleen, I'm glad to help!

Kathleen, I can tell you this because I work at a dealer myself and through the years when a problem comes in like yours and we can't find anything wrong its because whatever is causing the issue is not setting a code. There is only a few things that can cause a problem like yours and not set a code. (1) Fuel pumps can cause intermittent problem but will never set a code. After running for a while they will simply stop working but then after sitting a while will cool down and work fine again. (2) Exhaust issues. After the exhaust system has a lot of years and miles on it, the debris inside it can restrict the air flow and in some cases cause the vehicle to die and run poorly after a restart, but after sitting awhile the debris falls back down and the vehicle runs fine again until it happens again. NOTE: I'm not saying that either of these is your problem BUT, you have to start somewhere. Your only other option would be to let it die until the check engine light come on and then you'll know for sure it has set a code. After it sets a code then the dealer should be able to find your problem. The problem is that if its one of the issues I mentioned it will never set a code. Hope this helps and have an awesome day Kathleen.

Front brake caliper not releasing.Piston starting to seize

You will need to check every ground wire! Remove and clean each one. There are so many, too many to list! Frankster016