Sounds like the temperature gauge or temperature sensor is faulty and giving a wrong reading. Too high of an engine temperature will shut that engine down. Check the temperature with a temp gun if you can get one to see how hot it is before it shuts down. Aim it at the coolant line or the engine block. Or take the temperature sensor out and check it by putting it in a pot full of hot water with a temperature gauge and boil the water to see how high the temperature gets before the sensor closes or opens. Use an ohm meter across the sensor terminals to know when it's either opened or closed. Some of these are set up to operate in either open or close mode.
SOURCE: JOHN DEERE TRACTOR - MODEL A - SERIAL 642202 CLUTCH REPAIR
Try the John Deere web site, I think they will be able to help. donnyb60
SOURCE: system creeps down even when tractor is operating.
There are 2 potential problems -
1. Leaking spool on the control valve - rebuild the vale.
2. Cylinder blow-by. Disassemble piston and replace the seals.
To test if its the cylinder - retract the cylinders all the way... remove the hoses on the blind end (non rod end) of each cylinder, and again pull the valve to the retract position.
If fluid continues to pour out of the cylinder - the piston seal is damaged, and the affected cylinder must be repaired.
To test if the valve spool is faulty - disconnect the a and b ports just after the valve. Turn on the system and check for seepage from the disconnected lines (without moving the lever).
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: can't get front wheel off my john deere lawn tractor
remove the cap on wheel then there is a ring or cotter pin to remove then pull wheel off
SOURCE: John deere 2955 temp. gauge reads hot when it isn't hot
You need to take the temp gauge side of the dash off and check the circut bourd[physically inspect it]to see if the board is badf.If it's not then you probably need the guage replaced.{can't beleive they said live with it}If you don't get sattisfaction contact me again and i can fix this.
SOURCE: have a john deere lawn tractor. Blade will not
Check both belts on deck. Check if the clutch is clicking in. If not it will most likely need a new pto switch.
Sam
266 views
Usually answered in minutes!
×