Question about Motorcycles

1 Answer

Can someone please tell me what petrol I should put in my pioneer torro 125 cc please

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Motorcycles Master
  • 55,893 Answers

Hi, Jill excellent question, before I begin let me address motorcycles with valves and seats designed to run on leaded fuel issue, you can run unleaded fuel without a lead additive with no problem just replace the valves and seats with ones designed for unleaded fuel the next time you need a top end overhaul. In extremely rare cases some higher compression engines will ping using the highest octane graded unleaded fuel available in these cases the use of a lead additive or aviation fuel is recommended. Octane rating is a measure of a fuel's ability to resist 'knock'. The octane requirement of an engine varies with compression ratio, geometrical and mechanical considerations and operating conditions. The higher the octane number the greater the fuel's resistance to knocking or pinging during combustion.
The recommended octane rating for most motorcycles is usually octane 87, but be sure to check your bike's owner's manual. Ordinarily, your motorcycle will not benefit from using an octane higher than recommended in the owner's manual. However, some motorcycle models have high-compression engines and electronic controls, which are designed to benefit from the greater power output and improved fuel economy of high-octane fuel. Since octane requirements can vary with operating and environmental conditions, your bike may need a higher octane fuel than recommended to prevent knocking.
Bottom line, use the lowest grade octane that gives you acceptable performance without knocking or pinging.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
P1000 87 89 or 93 octane gas
Gas Facts
Haynes Manual 4871 Chinese Taiwanese Korean 125cc Bikes workshop service... $15
Quality Replacement Parts For Chinese Motorcycle
http://pioneernevada-parts.co.uk/zenshop/index.php?main_page=product_info&products_id=326

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Posted on Sep 25, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi can someone tell me the crankshaft shaft stump in mm. to fit a upgrade variators kit on a generic xor 125 cc 4 stroke scooter 2016 model?


Impossible to know something like that. It is not a spec. Take it to a local engineering shop and ask them to measure with a micrometer.

Aug 21, 2018 | Generic Motorcycles

1 Answer

Hello my cpi Aragon GP 125. Model 2012 when been on a run sometimes the carb spits petrol back through the air filter.l have to disconnect the air filter to empty it, then it will start again.??


Hi, Bryan spitting is usually caused by a faulty accelerator pump and or nozzle, or the float bowl needle and seat leaking and overflowing through the main jet mixing well nozzle, or the air-fuel mixture screw is set to lean. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Carb spitting out petrol Pit Bike Club
125 CC carb spits fuel out intake and sputters
CPI ARAGON Service Manual
CPI Scooter Parts
CPI Aragon 125 Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Apr 05, 2017 | Cpi Motorcycles

1 Answer

I have a pioneer receiver and my fuses had blown they say 125 v 6.3 A I went to radio shack to get them replaced and they sold me some that said 125 v 7 A and I put them in and they blew


The new fuses that you got have a higher rating than before - and they also blew. Tells you that you have a nasty short somewhere. I would check the power supply and/or output circuits.

Dec 17, 2016 | Pioneer Audio Players & Recorders

1 Answer

Hi, I put diesel on my honda Pantheon and need to know how to drain the diesel out and replace it with normal petrol.


Remove the petcock at the bottom of the tank and carefully drain the diesel into a suitable container. You may wish to add a little gasoline to the tank and slosh it around then drain that too. This will help to remove any diesel residue remaining .

I’m happy to help further over the phone at https://www.6ya.com/expert/robert_24775b73ca70da93

Aug 04, 2014 | MotoBatt All years honda pantheon 125 125...

1 Answer

2010 Peugeot 207 gearbox drain/filler/level bungs


The drain plug is situated on the final drive casing at the rear of the transmission (plug may need a square or hex drive wrench).

There is no level plug - the correct qty of oil must be measured and then poured in.
If Petrol 1.9 ltrs, diesel 2.0.

The oil is 75/80w.

Jan 19, 2014 | 2008 Peugeot 207 CC

1 Answer

I have a DVR-520H (Pioneer) and can´t record programs from my DECO (Pace DC550D) with hight channels. A last channel available is 125. Could you help me? Regards


Tell the PIONEER to "rescan" the channels, and be sure to scan for "digital" channels, so see if channels above 125 can be detected.

Sep 20, 2010 | Computers & Internet

3 Answers

Hello, i have a yamaha dt 125 r motorcycle and I have a problem release the front chain gear because the whole engine turns while i am trying to remove the nut from the gear.W hat should i do?


Did you try an impact driver? How about putting the bike in low gear? If not, just get a breaker bar on there an whack it with a brass hammer. I'm pretty sure it is a right hand thread. Hope this helps.

May 14, 2010 | 2004 Yamaha DT 125 R

1 Answer

Have a problem with my runner 200 vxr....gets to 65mph & like runs out of petrol. but chimes back in & runs fine. just wont go over 65mph?...someone has put a 125 carb on. but i have uped them main...


i have a the same ped with the same problem, il be fitting a molossi digital cdi and hopefully will be cured as it sounds to be restricted on the revs.

Jan 02, 2010 | 2005 Gilera Runner VX 125

1 Answer

I went on my kmx 125 earlyer and the petrol pipe has come off and i dont know wherte to put it back on...when i switch petrol pipe on it petrol is spilling on the floor any ideas thanks.


The petrol line from the gas valve runs to a brass fitting on the side of the carb just above the large bottom bowl.

Please rate this answer. Thanks JJ!

Apr 23, 2009 | 2000 kawasaki KMX 125

3 Answers

Engine turns over / Petrol OK/ No Spark


as with any problem you need a clymer book for your bike or you can disconnect the wiring harness(all of them one at a time)turn the key on and use a volt meter to make sure you are getting power.does the engine turn over?

Apr 20, 2009 | 2002 Suzuki VL 125 Intruder LC

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5856 Answers

Marvin
Marvin

Level 3 Expert

84625 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...