How could I hookup my led light bar to my Baja 125 dirt runner? There is no battery. It's a kickstart. I need alight on it asap.

you need to find the kill switch and remove the wires from the switch and attach them together if it is a 2 wire switch, lights dimming on break application is due to a short in the wires, common problem with integras 94-2001

You tried it in neutral but did you take it out of park and force it back into park? Just a suggestion since sometimes the switch that tells it that it is in park needs a bit of a nudge sometimes.

Your key is the kill switch. If you don't have a fob you can just put the key in the ignition and turn it back and forth several times (without starting the car) to turn alarm system off.

from http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c1528004bb9d
Have copied 2 diagrams below:

Remove battery cables from battery and clean them, replace bolts.

hehe, this is a funny one because the solution is rather simple. I only know about this because it happened to a friend of mine I was visiting in her older subaru, nearly brought her to tears - also, later I when I got my baja I saw it in my manual.

There's a little switch on the top of the steering column that's sole purpose is to turn on those lights without the keys in or having the vehicle on. Might have been switched on accidentally when setting the clock, or by some curious means.

Hope that was it!

On the steering column in front of the dash there is a parking light switch which has probably been flipped. I accidently flipped mine when I was wiping down the dashboard.

Truck Brake control

Red/Black stripe Black

Blue Blue

Lt. Blue/white stripe Red

White White

Orange Not used

Your brake light switch is eith stuck or gone bad.  It is located on the brake pedal and you can try to jiggle it to see if it will free itself and turn the lights off or you will need to replace it.  It's a pretty easy job and relatively inexpensive.  Let me know if you have any other questions.  Thanks for rating my response and for using FixYa!

that is a ground issue, check the grounds or negative connection of all the lights. what is happening is that the other lights are getting their ground from the other lights that is why when you swithc to that the light, the rear one goes off.

tnx for using fixya,

drcool