SOURCE: QRS-15 CP Rotoray screw.
G'day.
I guess only if the ISO 68 oil is also a full synthetic- otherwise no.
I would not mix them.
I would want to change all the oil & ALL the filters (including the seperator) before switching between a mineral & synthetic oil.
So it would be much safer/better to top up with the same oil until the next scheduled service & then switch to the better synthetic oil.
I hope this helped(I ran a compressor repair buisness in Sydney for 10 yrs)
Kind regards Andrew Porrelli
SOURCE: Oil
In many bikes the clutch work in oil and if you use an very good oil like sintetics with may be can cause a slipage clutch not when it is a new one but whne it have an use inportant the discs are more thin and the antifriccion oil can cause slipage more in the better oils like sintethics.
SOURCE: I'm running an old Echo300E with 40:1 synthetic
not at all, running it richer is always better than running leaner for peace of mind the engine is getting good lubrication.
Testimonial: "Thanks, I thought so. It runs fine except that I have to throttle down every 20 minutes and idle for a few minutes before it will give me RPMs again."
SOURCE: 2002 Road King FLHR CI, Is Lucas Full Synthetic 20W-50 Recommended for ALL compartments?
If Harley would not make their own line of Synthetic oil if it was bad for a Harley. I use Mobile one on my 2002 Wide Glide and never have had an issue with it.
SOURCE: Brand new Ryobi RG 950 won't start. Everything is
push primer 8 times and hold trigger wide open and try to start
91 views
Usually answered in minutes!
It also mixes the oil so I add oil to one compartment and gas to another
×