SOURCE: Is there any way to modify the stock exhaust on a
Yes, Buy a long drill bit and drill holes in rear baffels, I used 3/8 and started with 3 in each then drilled more as needed. But if you want it a lot louder you will have to drill from the front too. The drill bit I have is 18" long. If you can't find one like that you may need to use a drill bit extension.
SOURCE: need fuse box, help diagram or something telling
You will need a manual - but maybe get on line and go to the Suzuki forum or club for details
SOURCE: suzuki intruder 1500 LC I have problem with
Intruder carbs are notorious for this issue. What you have going on is that the needle seat has become worn out. The problem is, that this carb was designed with pressed in needle seats that cannot be removed. You will need to search online for an intruder carb rebuilder that can press in the seats for you, as well as change the seals, replace the needle, check the diapragm and jets, and replace/clean the floats. OR, you can try to find new carbs online from a wrecked or used Intruder 1500 VL.
SOURCE: 2002 VL 1500 Intruder LC: What is the proper tire pressure for Suzuki vl 150...
Tire pressure is 29 lbs for the front and 36 lbs for the rear
SOURCE: how to adjust clutch 1998 Suzuki VL 1500 intruder
The clutch on this model is hydraulic and is 'self adjusting", if the clutch is slipping the plates are worn out and in need of replacement. This information comes directly from the factory service manual.
221 views
Usually answered in minutes!
×