SOURCE: '95 Yamaha YZ 125 clutch - stays in gear when clutch is pulled in
hey dude,, just thought id come in and give u some tips or 3,, i take it when u pull clutch lever in, and try and change gear it feels like your foot will snap b4 it goes in gear,, if that makes sense,, firstly mate,is to make sure the clutch cable slides freely ,easest way is to take cable off and just grab 1 end and make sure it isnt sticky,, if so dip one end of the cable in a bit of old oil ,,whilst holdin the other end ,pull and push the cable inner, this will **** up a bit of lubricant inside the cable ,, keep doin this each end till free to move, ,,next step if the cables ok,,, and may need help if u dont no,drain the oil out,,and as u r sat on the bike is to remove the clutch casing on the right hand side of the moter,where the bottom end of the cable goes,remove the casing being carefull not damage the gasket,,then u will see clutch plates and friction plates housed,, undo the 7 or 8 spring loaded bolts carefully take the first fibre plate out then metal friction plate then another fibre plate and so on,, wen u take the 1st plate out place that on the bench ,stacking each plate on top of one another, cause they have to go back in as they came out,,wen out,,u need a piece of wet n dry paper ,or fine emery,,and just wipe round both sides of the fibre plates taking the shine off them,as u put them back in,, put casing back on with a decent gasket,, oil back in cable on, make sure cable has no free play on the lever so wen u r about to pull lever in it bite straight away,, start her up, warm it up and try it,,any probs still il eat my shoe,, take care m8
SOURCE: 2005 mazda 3 clutch won't engage
relpace the clutch pressure plate and throwoout bearing. It all comes in a clutch kit.
SOURCE: clutch not engaging properly
The clutch is not dis-engaging properly. Cables can stretch a bit. There shou;ld be an adjuster either at the clutch handle or at the transmission. Just take most, not all, of the slack out of the cable.
You should be back to normal now.
Please rate this solution as "FixYa" or post a comment if the problem is still present. Thanks!
SOURCE: My Clutch won't engage into gear. Need advice!
Did you check the clutch reservoir under the hood mounted on the firewall, driver side? Make sure level is up where it should be. If it's real low, you may have to bleed the system to get the air out. If you need to add fluid, use brake fluid.
SOURCE: 1998 kdx 200 clutch will not dis-engage
The clutch's plates must be stuck.Disassemble them and renew if necessary.The clutch lever should have 3mm freeplay and the spring's bolts should be tighten at 14Nm.
456 views
Usually answered in minutes!
×