GSXR 1100 WP Head torque settings

Details here on Page 94

11. Following the tightening sequence shown in
Figure 15, torque the fasteners in 1/2 turn increments and in two stages to the specifications.
Torque the fasteners to 1/2 the given torque, then
torque them to their final specifications:
a. Cylinder head nuts (1-4, Figure 15): 50 N•m
(37 ft.-lb.).
b. Cylinder head cap nut (5, Figure 15): 35 N•m
(26 ft.-lb.).
c. Cylinder head bolts (6 and 7, Figure 15): 20
N•m (15 ft.-lb.).
12. If the cylinder has also been reinstalled, torque
the cylinder bolts (A and B, Figure 23) to 10 N•m
(89 in.-lb.). One of the bolts sits in a recess (B, Fig-
ure 23) in the cylinder block.
13. If removed, install the locating pin (B, Figure
21) into the camshaft

Engine Lower End Torque Specifications - V star 1100

https://www.manualslib.com > ... > Owner's manual
Yamaha V star 1100 Manual Online: Engine Lower End Torque Specifications. Item N•m Alternator cover bolts 10 Connecting rod nuts 48 Crankcase stud 10 mm 20 ...

• 
  

  Cylinder Head Removal - Yamaha V star 1100 Owner's Manual

  https://www.manualslib.com > ... > Owner's manual
  Yamaha V star 1100 Manual Online: Cylinder Head Removal. The procedures for removing the rear (Figure 3) and front (Figure 4) cylinder heads are nearly ...
  
  
  videos that might help
  
  https://www.google.com/search?q=2003+v+Star+1100+head+bolts+torque
  
  ..

Vibrational resonances cause
nuts to loosen and are difficult to predict.

Use the correct torque setting to tighten nuts.

Consider a 'locking compound' such as http://www.loctite.co.uk/homepage.htm

Torque setting Toyota Land-cruiser 80 Series 4.5 1995-98
Engine code: 1FZ-FE, 1HD.
Stage 1: 20 Nm (Start tightening bolts from center to outwards)
Stage 2: 39 Nm
Stage 3: Rotate each bolt by 90 Degrees.
Stage 4: Further rotate each bolt by 90 Degrees

Answer barbo(fiat mechanic) Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.

I think its 85ft lbs. its been awhile, most shops tighten by hand until its tight and lock the nut with a cotter pin.

Cant see why it wont fit as I think the frames are the same onlly the engine siz is different

sound ok to me but check battery to see if it's ok

1.1 uno head bolts torque settings

Blocked pilot jets or unsychronised carbs

No They are Different They Wont fit..