SOURCE: how does a 2002 kawasaki ninja 250r act if the clutch isnt adjust
if there is no free play when pulling the lever in, the bike will most likely take off from first gear, but when you throttle it, the clutch will most likely slip. if the lever is to loose, lots of free play, you may have a hard time getting it in gear. approx 1/4 inch free play with the lever and it will work normal... unless its ready for a new clutch. hope this helps...
SOURCE: My daughter dropped her 2009 Kawasaki Ninja 250r.
Do what you have to do, Keep all your screws in a bowl or jar so you will know when you have them all back in. Look at each screw you take out and you will have a mental picture for reassembly. Don't take anything apart and walk away from it. It won't tske long if you stay with it until it's fully reassembled.. Good luck
SOURCE: my 2009 ninja 250r starts but dies when you remove
I had the same problem.. choke cable had to be adjusted. Check the manual, I don't have mine handy but the measurement is in there.. check it out.
SOURCE: need help
if its the right key, then use picks to extract the key piece, and have new one made. or find the largest red wire exiting the switch, apply power, may also be more than just this wire that needs power on some bikes.
SOURCE: my 250r kawasaki ninja will not start, it starts
I have same problem on my 2007 250 it starts when I hold the choke when I release it it dies,my email is [email protected]
Thanks
596 views
Usually answered in minutes!
×