Can I put 1 inch handlebars on 86 Honda shadow LVT 1100? They are a pain or's and they don't taper down to 7/8 of an inch at the end

Matthew Spark

• 1066 Answers
• Posted on May 27, 2008

SOURCE: 32 inch Sanyo Vizon LCD

is there a magnet in close proximity to your tv, perhaps an unshielded speaker?

SOURCE: rewiring, changing ape hanger handle bars to std

Try looking up Powersprtseast.com They have a parts fische you can use and though not in color itself may have colors labled on diagram for wiring harness.

SOURCE: I am changing the handlebars to 16

To change the throttle/idle cables, first you need to remove the fuel tanks so you can get to the carb/throttle body. Loosen the adjusters at the throttle grip on the handlebars. Remove the idle cable first and the remove the throttle cable from the carb/throttle body. Then take the two bolts out of the throttle grip housing halves and carefully seperate them. Remove the old cables from the twist grip. Reinstall new cables in the reverse procedure. Before starting the bike, make absolutely sure that the throttle cables work like they're supposed to and the carb/throttle body will close completely.

To remove the clutch cable, remove exhaust system or whatever might be in the way on the right side of the bike. You need to remove the right side transmission cover. Drain the transmission oil. Remove the chrome right side transmission cover. Disconnect the clutch cable from the clutch release mechanism. Screw the end of the clutch cable out of the cover and take the cable loose from the clutch lever on the handlebars. Reinstall in reverse order making sure you install a new O-ring on the cable at the transmission cover. Replace cover and refill transmission with oil. Reinstall anything else you had to take off.

SOURCE: @sbcglobal.nethow long should the clutch

I usually use a piece of wire and tape it the original cable until the cable stops. Then, I run the wire on up to the clutch lever. Remove the wire and measure it.

Then go to Barnett's site and order the cable or see if they've got a "ready made" cable.
http://www.barnettclutches.com/products/custom_measuring_guide.aspx

Good luck
Steve

SOURCE: I purchased 16" Demon ape

go to the harley dealer near you and explain your problem, I don't know if they still have them, but you could used to get the top clamp for after market bars that had a smaller diameter, they weren't that much and bolted right on,