Motorcycles Logo

Related Topics:

Brian lloyd Posted on Sep 22, 2016

2007 kymco 250 xciting scooterjust rebuilt motor and now I can't get motor to turn over.starter and battery r good.when I try to start all it does is click threw the solenoid.someone please help....

1 Answer

Loveall

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Corporal:

An expert that has over 10 points.

  • Contributor 16 Answers
  • Posted on Sep 22, 2016
Loveall
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Corporal:

An expert that has over 10 points.

Joined: Dec 06, 2008
Answers
16
Questions
1
Helped
3063
Points
42

A clicking starter solenoid is usually caused by a discharged or defective battery. I would charge the battery and check the connections. The battery voltage should remain above 10 volts WHILE CRANKING.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 09, 2008

SOURCE: Starter fails to start.

I'm having the same problem. The dealership keeps telling me it's the starter. I've replaced starter and still have the same problem. I have had all the wiring and new key swith put in and still have the same problem. I guess were in the same boat!!!

Ad

Anonymous

  • 370 Answers
  • Posted on Oct 08, 2009

SOURCE: '97 Ford F150, clicking noise when trying to

you need to check for voltage drop in the wires you may have a bad wire bleeding to ground somewere that needs replaced also put a multimeter on the starter and make sure its gettting atleast 11 volts to it anything less and it wont turn hard enough

Mike

  • 4383 Answers
  • Posted on Nov 02, 2010

SOURCE: Put new (rebuilt) starter on last weekend, this

Bummer. Sometimes rebuilt starters are not actually rebuilt, but repaired. this means they fixed the issue, but did not replace bushings, brushes, etc...

try hooking up a wire to the actuater terminal of the starter (usually the small one at 2 o'clock position) and connect test light to it an ground the test light. Run this wire inside the cab so you can see it...When you turn to start, this light should light. Run vehicle until problem happens again and if the light illuminates, the focus is the starter, if it does not, you need to look at the entire circuit. Look carefully at neutral safety switch and connections..

Testimonial: "Appreciate the info, I will try what you suggested this weekend. Thanks!"

Anonymous

  • 594 Answers
  • Posted on May 08, 2011

SOURCE: 2004 Sante fe 3.5L 2WD went out to go to work and

TEST POWER LEADS TO STARTER FOR POWER
AT STARTER (BATTERY POSITIVE TO STARTER BATTERY NEGATIVE TO ENGINE BLOCK)
THEN TEST FOR SIGNAL POWER TO SELENOIDE ON STARTER
(KEY TURNED TO START POWER SHOULD GO TO SELENOIDE)
IF NO POWER TO SIGNAL WIRE CHECK FUSES AND RELAYS
ON STARTER CIRCUIT
IF THIS CHECKS OUT MAY BE AUTO TRANSMISSION NUTRAL PARK SWITCH
TRY TO START IN NUTRAL OR WHILE SHIFTING TRUE GEARS SLOWLY WITH SHIFTER
IF STANDARED CHECK NUTRAL SAFETY SWITCH

Testimonial: "I will check all of those dtmajor. thank you very much for your help. I would have paid for assistance but no C card here. Thanks again"

Anonymous

  • 116 Answers
  • Posted on Jun 06, 2011

SOURCE: 2007 chevy cobalt ls won't

Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
2answers

Kymco 550 starting problems @

If it will not crank then the battery is probably drainedCheck battery voltage with key on, key off & cranking & get back to me
Ride Safe
Bike-Doc
0helpful
1answer

My kymco xciting 250 wont start. i have not ridden it over the winter. i have gassed it up and charged the battery. when i hit the starter the lights blink on the panel but it will not turnover.

Did you warm up your Kymco during winter? If not then your first priority is to have your battery professionaly measured for cranking power capacity or get a new one..
0helpful
1answer

I have an 2008 Xciting 500 that will not start when it is below 40 degrees. Any solutions? @

kymco 500 has no air temp sensor,ecu reads water temp for coldstart enrickment.a new sender wont fix it ether,sender needs to read 10 degrees warmer to start
Not finding what you are looking for?

136 views

Ask a Question

Usually answered in minutes!

Top Kymco Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...