Question about Kymco Motorcycles
Posted by Anonymous on
Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Kymco, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
how to set and adjust the cam and cam chain timing 4 stroke engines ATV...
How To Set Cam Timing
Valve Cam Timing
KYMCO ZING 125 Manual
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e
Posted on Aug 02, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: No power on my Kymco Zing 125
your best try is to contact your dealer, and get them to order you the short red wire that runs from the + terminal on the battery, to the starter soleniod ( also has a thin red wire that runs to fuse holder) i had exactly the same problem and this solved it. i have however re done all the electrical connections on my bike using 7amp wire and bullet connectors, as i have had many faults with the electrics before.
My bike is a Kymco Cruiser 125 (almost exactly the same bike, i use kymco zing parts when replacing) i paid approx £16 GBP for the wire.
Posted on Oct 05, 2009
Not always necessary to change the regulator/rectifier. Check all connections to make sure they are clean, use a good contact cleaner and finish off with dielectric grease on your electrical connections.
When some bikes get a few years on them the connections get dirty. Check to see if there are any burned or discolored wires anywhere around the regulator. The FIX on some bikes is to cut the connector completely out and solder the wires together and either seal them with heat shrink of a good electrical tape. Loose or bad connections get hot. As long as the regulator and rectifier are working there is no need to replace them if the connections are good.
Ride Safely, Ed
Posted on Apr 09, 2010
SOURCE: What is the oil capacity
I would put in 2 qts and then slowly add part of the third till the level comes up. No bike, not even a big one holds much more than 3 qts oil. But I'm sure you will safe at putting in 2.+. Hope this helps.
Posted on May 28, 2011
I found an owner's instruction manual on the net in Spanish that says:
0,05 mm - 0,1 mm
This means that the valve clearance is 0.05 to 0.1 mm. A slightly tight adjustment using a 0.1 feeler gage should be ok and the real clearance would then probably be ca. 0.08 mm.
Posted on Oct 08, 2012
Tips for a great answer:
Mar 05, 2018 | 2003 Kymco Hipster 125
Sep 05, 2016 | Kymco Motorcycles
Jun 06, 2016 | Kymco Zing 125 Motorcycles
Sep 30, 2011 | 2005 Kymco Zing 125
Jun 18, 2011 | 2005 Kymco Zing 125
Oct 22, 2010 | 2005 Kymco Zing 125
Mar 14, 2009 | Kymco Zing 125 Motorcycles
122 people viewed this question
Usually answered in minutes!