Power will not come on when ignition is turned to start

replace the battery as there is not enough charge to start and provide power for the ignition
when you pull start the max power is provided to the ignition system

Most all vehicles have main power cable to starter solenoid which is mounted on the starter where the power cable to the switch connects OR there is a separate heavy gauge red wire connected to the positive post of the battery that leads to the ignition switch. Also check your ground cable by connecting battery jumper cable to negative post on battery and other end to metal frame of van.

indicates a bad battery
when the starter is engaged there is not enough power left for the ignition system
when push start all of the power goes to the ignition system and it starts
lights are no indication of a good battery
take it to a bike auto electrician specialist shop for a charge system check

There could be a bad battery connection or possibly even a bad ignition switch causing momentary loss of power to the Central Timing Module or the

these cars are known for bad ignition switches

Check your starter relay, it is mounted to the fenderwell near the battery. On the relay there is a terminal labeled "S" take that wire loose and check for power when the key is turned to start, if there is power you need a relay, if there is none you have and ignition switch or safety neutral switch problem.

Check, clean and tighten your battery posts, and the power connection to the starter and ground. Make certain the battery is good and charged, Perhaps you have a bad starter motor, or the engine is frozen (will not turn over). I think the ignition switch is okay, because your lights dim when you try to start. This indicates power is getting to the starter (at least some).

check starter for power on main battery wire and on smaller wire from ignition switch while someone turns the key if your getting power on both wires it's the starter if you want you can also tap on the starter and starter solenoid while the key is being turned and see if it starts but it does sound like starter to me if your not getting power to the starter on the small wire make sure your alarm isn't interfering and check ignition switch

Help please....I have Mazda Protege 2002...the car was driving good..and suddenly the car didn't start at all i changed the starter the battery is fine because when i start the car the lights comes on and the radio works. I don't know what is the problem is...when i start the car it makes noise of tik tik. Please help me????

Measure the charging system.Battery, regulator/rectifier and stator output volts.At 3000rpm you should see on your battery 13,5-14,5V with your high beams on.Your battery disconnected should show 12,5V.