2003 KX125 glycol seeping out of vent line underneath reed valve block. I replaced the crank bearings Resealed case halfs with Kawasaki liquid sealant. New cylinder base and head gaskets. Ridden hard once then put up in barn for winter. Some days in single digits. Had small amout of glycol puddled on bucket stand.
SOURCE: anti freeze driping out of seep hole from the bottom of case
hello
there are two different seals on the water pump. the oil seal and the mechanical seal. the oil seal helps seal out the oil from the trans case. the mechanical seal helps seal the coolant from going into the trans case, and vise versa.
the weep hole is there to help diagnose if either seal is faulting. so if coolant is leaking from the weep hole. the mechanical seal is faulting or if the oil seal is leaking oil will drip from the weep hole.
hope this is of some help. thank you.
SOURCE: wont start by kick start but will by pull start
it could be the gaskets around your carb are bad and leaking air if so its thinning your gas fumes with more air then what is needed inside your combustion chamber witch is causing your engine to stop running like that. best of luck
SOURCE: 2001 Kawasaki prairie 300 ATV
The head and cylinder can not be removed as a single unit. You will need to put the piston on TDC compression, then check for the cam positioning mark or marks to see where they line up. This is the exact positioning the cam gear must be reinstalled at. Remove the cam gear from the cam and the chain but first hook a piece of wire to the chain so it can't fall down into the crank area. Now the head can come off then the cylinder. The simple diagram is your engine. the other one is generic and shows alignment. Please rate my answer. Thanks.
Testimonial: "Thank you sir, your knowledge was a great help, it came apart just fine. Now I've seemed to have gotten it out of time. "
60 views
Usually answered in minutes!
×