New battery brake lights work but no click when starter button pressed
SOURCE: kymco people 150 when i push the starter button
The starter relay needs replaced. If you follow the + wire from the battery, it goes into a box with a + wire on the other side of it. If you jump power across the two wires, it should start
SOURCE: hi,iwould like to fit a remote starter on my
you will have to use a relay. connect pin 85 on the relay to the negative out wire on the remote starter, this wire is the bypass wire, then connect pin 86 to constant 12volt, then pin 30 will goto 12 volt constant aswell and pin 87 will go to the wire on your brake leaver that sends 12 volts out (there is probibly 2 wires coming from the brake leaver switch) connect 87 to the one that does not have 12volts on it at rest
SOURCE: Derestrict 2007 kymco agility 50?
Ckeck spark plug,batterie,put super fuel with a hight level of octane its gonna clean ir engine .
Check with a multi tester for voltage coming through the ignition switch lead wires + to switch wire - to ground you shoul get 12volt or higher, with the switch off you should have one live (feed from battery ), on you should have 2 or 3 in and out feed (possibly 2 out one for ignition one for light curuit), or disconnect the switch and check for continuity (12v battery wire and a bulb if you dont have a multi tester between each pin on the switch plug when turned on you should get a curcuit when on.
1,938 views
Usually answered in minutes!
×