When i start to go i lose power and stalls i can't go very far and stalls

Check for trouble codes.

Check fuel pump, that's how the act when they go bad, the beeping is the engine stalling.

don't put the pump nozzle in to far u will find it will fill quicker an for the car stalling tweak it a little

Can you perform a spark test? I would like to know if it has spark when it stalls. Also, if you have a can of starter fluid, wait for it to stall and not want to restart, the quickly spray some starter fluid into the intake. If it runs on the starter fluid, you have a fuel issue. You might also want to make sure the engine coolant level is fine and you aren't overheating. If you coolant level is low you may not know it is overheating since the coolant sensor isn't in coolant. It won't read air.

It could be the coil is getting old. They begin to lose function when they warm up.

You have not done the most basic test to see what is going on, that is to scan the engine control computer (ECM) for fault codes.

Sounds like valve timing has slipped. Are the other cylinders much higher in pressure or about the same?

This could be a clogged air filter and /or fuel filter. start there. Also a dirty throttle body can cause this. Use brake clean to clean this. you only need to clean the inside of the throttle body , use a small brush and clean as far as it will reach, also clean the back of the plate. Start it (might take a minute) and spray the brake clean into the throttle at higher rpm's.

Try loosening the gas cap just as it begins to lose power. If this clears the problem, clear the vent holes in the cap.
Gary

try adjusting the throttle position switch very hard to adjust right car will hesitate , not idle properly and hesitate when accellerating if not adjusted properly.