SOURCE: 110cc pocket bike carberator
That tube would be the overflow tube. Your carb float is sticking open and allowing fuel to flow in constantly. You need to take carb apart, clean needle valve, and inspect or replace carb float.
SOURCE: pit bike
yep oil ring gone, oils traveling past the piston and mixing with the fuel,cheap and easy to change,
SOURCE: wen i start my 110cc pit bike it revs loads with
sounds like mixtue screw ,ave a fiddle its the screw wiv the spring on it ok , or take off air filter and try
SOURCE: NO SPARK,110CC, 4 STROKE,NEW STATOR,CDI,AND RECTIFIER
Hey whats up? Try back probing your wires going to the CDI unit with a volt meter or continuity tester to make sure you do have any broken wires. Then check the stater make it is good. If sure how to check the starter take it a bike repair shop they should check it for free.. If that does work let me know and I will look further into it for you. Good Luck.
SOURCE: no spark 110cc engine wont start
Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.
If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.
Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.
Please rate this answer. Thanks
598 views
Usually answered in minutes!
×