Got a runner st 125 4t and when press start button won't fire up but makes a clicking noise anyone know what it could be cheers

SOURCE: Replaced positive battery cable + spark=bike will not fire up

I am afraid to make assumptions as to what else you have checked due to some negative feedback. Did you LOAD check the Battery? Did you check and clean your grounds? If you have done all of that the next logical problem is the solenoid, which can be rebuilt.

SOURCE: turn on ,press start solenoid clicks thats it 1999

First check is for power (a voltmeter or test light) at the solenoid terminal that connects directly to the battery. If no power, the battery connection is bad or the cable is open. If ok, test the starter motor terminal for power when the starter button is pressed. If you get power, the starter motor is bad--likely brushes or broken wiring somewhere inside. If no power, then the heavy contacts in the solenoid are in bad condition. If it has a sealed case, it must be replaced. If you can get into it, an eroded contact can be built-up with silver solder (from a welding supply) (the higher the silver content, the better the repair) and shaped with a file. Good luck!

Testimonial: "thanks for the help ,am working on bike now,regards paul"

SOURCE: I've a W reg gilera runner 180SP & theres no

hi mate there is a fuse if you take off the horn cover panel there you should see 4 fuses near the bottom just take each one out and check them

SOURCE: gilera runner vx 125cc wont start

check for a loose wire on the relay or battery, or selionid

SOURCE: 2002 Harley Davidson won't start making a clicking Noise

check to make sure the fuzes are good and the bat still has juice if all good then check the starter