Will not charge first time

Have you let the loco charge first? The instructions are a bit vague but the loco needs to charge before it runs. Not easily understood from the instructions and many have spent some frustrating hours wondering why their train wouldn't move.

PLEASE CALL THE QUINGO CUSTOMER SERVICE LINE ON 01582 430900 AND ASK FOR JULIE SHE WILL BE ABLE TO HELP

Is this E-150 econoline?
Engine running, take reading at generator bat terminal, what is it? The basics, take reading across battery terminals, everything off. Take second reading at bat terminals, engine running. The second reading should be higher than the first if charging system is working. Was the charging system checked on the vehicle when the generator was checked out?
There could be a wiring circuit problem? The bat terminal at generator is hot all the time, engine running or off.

that's becasue the new abattery went dead because it was not charging. The battery light must be OFF to charge the battery. Take it back to whoever fixed it. May be a bad wire betwen battery & alternator too.

check the 175 amp mega fuse in the engine compartment.

cehck this ground for a good connection - G104
Left front fender near air cleaner

check the 20 amp fuse for the charging system. Fuse 26 in teh engine compartment fuse box.

Sounds like it needs a battery.
After a few years those batteries will charge up to the correct voltage, but the length of time that charge lasts gets shorter and shorter, You probably have a drill, a razor, a laptop computer, or a flashlight that do not hold a charge as long as they used to, I know that you have a camera that doesn't hold a charge .
Sounds like a battery problem,

Take the ethernet cable which is going from your Warner cable modem to your computer, and run it from your cable modem to the input connection of your router. Then take a second ethernet cable and run it from the router (ports 1, 2,3 or 4) to your computer. Log into your router's setup page (see your instruction manual), and set up all the passwords and wireless settings. Please read the instructions for specifics of your particular router.

I actually fixed mine... please read all instructions b4 making actions...
i dont know how but ill tell u wat i did. (brace urself.. i will rambling a bit with unnecessary details, but it may help u... SO
i went to target... where i bought the camera and

1. bought a new battery b/c other forums said its the battery thats deffective.... This didnt help because i put the new battery in and it did the same thing.

2. i cleaned the new battery with a q-tip (the 3 metal parts.. and the inside of the camera where the metal parts connect) This did not work either

3. Clicked it to FAVORITES cuz i knew it was able to review pictures... i clicked menu and i reformatted the Month day and year and time (because it said it was wrong)... that didnt help...

4. finally... i decided this may work like the iPod.. so i held down the ON/OFF button while holding down the Time/Ascending Folder button (its in the circular panel where OK button is ... it is the button under OK on the circular panel) ... and eventually that green blinking light kept blinking... and all of a sudden i the monitor was showing picture again .. i took a picture of myself... deleted it... went back to camera mode... turned off the camera turned it back on... and its back to normal....

4- 1/2. I but back in my old battery... and it works like normal

IN CONCLUSION.... maybe its not ur battery. .so b4 u go out and spend 29.99 onn a new rechargable... follow my instructions and maybee it will work for u too!!

I have a Pioneer Premier Deck in my van and I get the same problem I just unplug it and plug it back in

Hi, I have bought a second hand roger black silver cross trainer and I do not have any instructions, also the bolt that holds the front post together is missing and the tension dial does not seem to work can I adjust the tension in side the front post! Please can you help. Kind Regards Janet

Put watch in direct sunlight, in a window for 8 hours. If battery indicator shows the watch is fully charged then you may need to look at what mode your watch is in.