2000 Yamaha YZF-R6 Logo
Pedro Villagrana
Pedro Villagrana Posted on Sep 17, 2015
Answered

Why doesn't engine turn over?

How do I get my r6 engine to run? Installed a switch for ignitionand everything works except for the motor not turning over

Answer This Question

1 Answer

antreou

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.
Corporal:

An expert that has over 10 points.
Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 17 Answers
  • Posted on Sep 17, 2015
antreou
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.
Corporal:

An expert that has over 10 points.
Mayor:

An expert whose answer got voted for 2 times.

Joined: May 01, 2011
Answers
17
Questions
0
Helped
6883
Points
44

Check the battery.Is it charged?Also does the neutral light go on?
If not check the neutral switch.
The neutral switch is behind the engine case near the rear shock and has one wire. Make sure the bike is in neutral or on stands. Remove the one wire and put it to earth/chassis/ground (somewhere metal on the bike). The neutral light should come on and you should be able to start the bike if that was the problem.

Testimonial: "Thank you very much for your help...it fired right. Up after i did what you suggested!!! I was ecstatic....thank you again"

  • Pedro Villagrana
    Pedro Villagrana Sep 17, 2015

    Thank you antreou...I appreciate it very much. I hope that was the problem

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0answers

My r6 doesnt turn fully on disengage the headlight assembly everything turns on like normal.but then it wont turn over. I just get this buzzing sound from high and low beam relays. wiring looks fine
Read full answer
Be the first to answer Apr 28, 2016 • Motorcycles
0answers

I am bypassing my ignition on my 2004 r6 and the fuel pump and display turn on but it wont turn over
Read full answer
Be the first to answer Apr 17, 2014 • 2004 Yamaha YZF-R6
1helpful
1answer

Engine running, heater fan, wipers, turn signals and 4 ways don't work. Radio works, when i turn ON the headlights the "left your lights ON" Buzz's seems that everything that should work on ACC doesn't...
Must either be the ignition switch itself failed, and/or the ignition relay has failed.
Read full answer
Apr 10, 2014 • 1982 Ford F 350
0answers

My 2006 r6 starter relay clicks like a dead battery and my bike wont start and my starter just spins my motor wont turn
Read full answer
Be the first to answer Sep 01, 2013 • Yamaha YZF-R6 Motorcycles
1helpful
1answer

Blikers only work with running lights off
You have the tail light you just installed wired wrong or if the new tail light is a LED tail light your looking at the LED's possibly not drawing enough power to make the flasher work. change the flasher to a LED specific one.
Read full answer
Nov 14, 2012 • 2001 Yamaha YZF-R6
0helpful
1answer

I have a 1990 Arctic Cat Cheetah Touring and everything runs well except when you turn the key to start the motor, it won't start. Turn the key to run position and short out the two power terminal
Well, I can probably help you but you will need a Voltmeter and know how to use it. Shouldn't be too much of a diagnostic problem but the VM is first. Do you have one and know how to use it?
Read full answer
Aug 02, 2017 • Toys
0helpful
1answer

I am having problems getting my bike running and keeping it running. I will have to hold the stop engine switch down in the on position to turn on the bike sometimes. Even once it's on sometimes the...
replace the kill/stop switch.
Read full answer
Sep 03, 2011 • 2004 Yamaha YZF-R6
0helpful
1answer

1996 1500 chevy Z71 ,350 engine. Everything works electronic except when you turn key on it won't crank
First try getting a boost. It could be just a low battery. The starter takes much more power than everything else together. If you have already tried that, or it doesn't help, try shorting out the starter with a screwdriver. If it works , your ignition switch could be faulty, or the neutral switch for the shiter.
Read full answer
Jul 16, 2011 • 1997 Ford Expedition
1helpful
2answers

My r6 turns over lights on everything works except the neutral indicator light does not come on and the ignition button on the right wont work doesnt start up the bike
how did you fix your problem? the same thing its happening to me
Read full answer
May 05, 2011 • 2008 Yamaha YZF-R6
0helpful
1answer

Ignition wont turn off
Hi and welcome to FixYa,

Offhand, it would appear that some of the contacts of the main (ignition) switch has fused together. To check, with the ignition switch off and key removed, all wires from the ignition switch must have no 12 volts reading except for the red.

Good luck and thank you for asking FixYa.
Read full answer
Jun 28, 2009 • 1999 Yamaha YZF-R6
Not finding what you are looking for?

View Most Popular

2000 YZF-R6

  • Motorcycles

Related Question

My r6 doesnt turn fully on disengage the headlight assembly everything turns on like normal.but then it wont turn over. I just get this buzzing sound from high and low beam relays. wiring looks fine

  • Motorcycles

Related Topics

257 views

Ask a Question

Usually answered in minutes!

Popular Questions

How do you set the timing on a yamaha warrior 350

2000 Yamaha YZF-R6

R6 ECU reset on yamaha

2006 Yamaha YZF-R6

How do i remove battery from 2008 yamaha r6

2007 Yamaha YZF-R6

Remove the seat

2008 Yamaha YZF-R6

My 2005 YZF-R6 is sputtering and has a lack of

2005 Yamaha YZF-R6

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...