2007 raptor 350 ticking? - Yamaha Raptor Forum
www.raptorforum.com/...raptor-350.../23854-2007-raptor-350-ticking.h...
Nov 30, 2007 - if its 100% stock then no there shouldent be any ticking, if its only 4 days old take ... as i got it up to crusing speed for a few minutes.. you'll get used to itsnoises. ... eng temp, rpm, custom one off intake, polished engine covers,.
Ticking Noise - Yamaha Raptor Forum
Aug 5, 2014
2008 Yamaha Raptor 350 making grinding noise . . . - Yamaha ...
Sep 13, 2011
How To Avoid Hot Cam Ticking? - Yamaha Raptor Forum
Jan 30, 2011
raptor 350 knocking???? - Yamaha Raptor Forum
Mar 6, 2010
More results from www.raptorforum.com
SOURCE: yamaha tw. noise from engine
Check and reset (if needed) the valve clearances. With the engine cold, set the intake to .002 and the exhaust to .003. Is the cam chain tensioner set properly? Burn premium gas and install a new NGK spark plug one heat range colder than stock to lessen any possible pre-ignition. Are there any signs of wetness, oil or blackish discoloration on the base of the cylinder head? > A blown head gasket can make a ticking sound also.
Please rate this solution. Thanks Kenneth!
SOURCE: raptor 350, gears slip at full throttle. Is there an adjustment
sounds like you need a new clutch. but first make sure that your clutch cable is'nt too tight. it should have a little bit of freeplay when you pull the lever.
SOURCE: I have a 2007 yamaha raptor 350, and there is
If you hear the knocking all the time and it sounds like it coming from the lower part of the motor then i would have to say you may have a rod bairing gone bad. If you hear it at the top end of the motor then you have a wrist pin or piston slap. Eather way you will have to remover the motor and disasemble it to repair it.
SOURCE: 02 YMF660 Yamaha Raptor won't rev
dude i have a 02 rapter 660 the reverse light was on and it wasent reving i took the battery out and took the ecu out and i found some disconnected wires fixed them and every thing was fine. if you still have a probley with it check the ecu...
1,350 views
Usually answered in minutes!
×