SOURCE: 2001 yamaha roadstar silverado doesnt start. not
OK, been here already. I believe it was a loose ground from battery to frame/engine. Good Luck.
SOURCE: How do you check the oil in a 2003 yamaha roadstar
all bike are to be checked in the upright position! then find out how much the bike takes from your manual if you dont have a manual ...do the following ..when you just change oil and not filter you will be adding less oil,"almost" all bikes take @ 3 quarts oil minimum, so what i do to be safe!! is always after draining is put in two quarts no problem, but with the third bottle i only pour in half.. drop oil cap back on and start the bike and let it run for a minute, the turn it back off, then check oil level, if it doesn't register anything on the stick or sight glass then your o.k. to add the rest. now take a reading, and only fill to almost full, i always under fill my bikes, because over filling will cause damage to internal bearing by the air bubbles from the splashing of the crank in the oil pan. Same as cars.
If you found this helpful can i get a rating?
Thanks
SOURCE: Try to start my 1600
is the battery flat?.start with that!!..if not..are the battery termanials done up tight on the battery...then check that solenoind termenals are done up...hope this helps
SOURCE: How do I program my clock on my 2001 Yamaha
View the service manual at this URL : http://www.scribd.com/doc/17625151/servicemanual1602082008 : and scroll down to printed page 3-62 or electronic page 120.
Copying from that page:
1. Turn the main [ignition] switch to "ON".
2. Press both left and right buttons simultaneously [i.e., the 2 buttons below the speedometer glass] until both hours and minutes flash
3. Push the left [mode] button and the hour display will flash
4. Push the right [right] button to change the hours.
5. Push the left button and the minute display will flash.
6. Push the right button to change the minutes.
7. Push the left button and both hours and minutes will flash.
8. Push the right button for two seconds to set the clock.
Testimonial: "Awesome answer thank you so much!"
SOURCE: yamaha roadstar 1600 yr.2000 digital
The first thing you can do is check the fuses, the fuse box is either under the seat or behind the cover on the left side as you are sitting on the bike, if all is good then remove the speedo cluster and connect it to your battery directly, Here is the procedure from the manual CHECKING THE LEDs The following procedure applies to all of the LEDs. 1. Check: LED (for proper operation) a. Disconnect the meter assembly coupler (meter assembly side). b. Connect two jumper leads 1 from the battery terminals to the respective coupler terminals as shown. WAWRNARINNGING • A wire that is used as a jumper lead must have at least the same capacity of the battery lead, otherwise the jumper lead may burn. • This check is likely to produce sparks, therefore make sure that no flammable gas or fluid is in the vicinity. c. When the jumper leads are connected to the terminals the respective LED should illuminate. Does not light ® Replace the meter assembly. This will tell you if it is the meter, If the meter is good then you will need to follow the wires connected to it till you find the problem. I hope this is a big help to you.
7
1,037 views
Usually answered in minutes!
×