Question about Motorcycles

1 Answer

Why wont carburetor idle down - Motorcycles

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 66 Answers

The same amount of fuel/air mixture into the engine and the same amount of exhaust

Posted on Jun 01, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Echo only runs wide open


Your question isn't detail enough such as.

Q: It starts up wide open with the trigger depress fully but when I release the trigger it dies.

A: The carburetor idle jet (Picture A item #27) is dirty/plugged. the carburetor needs to be taken apart and cleaned or it just needs to be turned out a bit to flow fuel or the idle screw that sets the idle speed (Picture B) on the carburetor need to be screwed in to open the flap a bit more. Your carburetor may not be like either of these two carburetors but close enough. If you need to figure out which carburetor you have to locate the idle jet look search for picture of your carburetor and that tells all such as in picture A.

Another couple things. In picture B you see the spring on the throttle shaft that closes the flap to idle. If that area is really dirty the flap could be stuck wide open. Make sure the it is free to open and close. If the chainsaw has had a lot of use the engine could be wore to the point at idle the piston isn't making enough compression for the engine to stay running even if you turn the idle speed screw (Picture B) in as far as you can.
26256623-1ts0so3wcqkptntjrthxjlss-1-0.jpg

26256623-1ts0so3wcqkptntjrthxjlss-1-2.jpg

Aug 10, 2016 | Echo Garden

1 Answer

Motor will not idle down


Your carburetor is the problem. Either have it serviced or get a new carburetor. You can service it yourself, you will need carburetor cleaner, very thin gauged wire, air compressor if you have one to blow out the ports etc..

Also you can check out you tube for videos on how to clean a 4 cycle carburetor

Nov 05, 2015 | Ryobi Gas Pressure Washer: 3100 psi 2.5...

1 Answer

My Rochester carburetor wont idle and t won't run


Blocked jets remove strip down and overhaul ,fit new gasket s.

Aug 31, 2014 | Cars & Trucks

1 Answer

How do i adjust the carburetor for the idle


some have a small screw on the carb next to the throttle plate

Apr 26, 2012 | Ariens 21 In Classic Walk Behind Push Lawn...

1 Answer

Cant get my 03 wideglide to idle at lower rpm,bike dies down when lowering idle screw


Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals especially the ground cable at BOTH ends, ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For a prime suspect please visit website below and good luck:
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Mar 23, 2012 | 2003 Harley Davidson FXDWG Dyna Wide Glide

2 Answers

I have a kawasaki lakota 300 (2001) It starts and runs with the choke on soon as i turn choke off it dies idle adjustment screww does nothing. I can here that it is working. Ive ran it up and down the...


You need to take off your carburetor , disassemble it, and clean the jets (specifically the slow jet) and the passageways in the carburetor body that feed the gas to the carburetor throat. Carefully set your air screw setting back to stock setting. and reassemble. Inspect the intake manifold and air box tubes for cracks and separations. That should get you idling again.

Oct 06, 2010 | kawasaki KLX 300 Motorcycles

1 Answer

Engine hard to start wont idle sometimes wont idle down when shifting or stopsd


Won't idle down: look for dry/rusted/frayed inner throttle cable. Look for sluggish fuel flow from tank for starting problem. May have to clean the carburetor(s) and fuel filter. Are the spark plugs clean and gapped correctly?

Aug 18, 2009 | 2005 Buell Blast

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5924 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

1400Slugg

Level 2 Expert

260 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...