Purchased new in +/-1992.Need to find right carb. Frame number EA7-1101221, Engine GC05-2054125. Can not find a vin on it anywhere. Part catalog listed 3 variations.

Hi Gilbert:
Seriously, it will be on your registration.

The frame serial number is stamped on the
right side of the frame down tube.
The VIN number label is located just below
the frame number on the right side frame down tube.
The engine serial number is stamped on a pad on the left
side of the crankcase and the right side of the
crankcase. not sure if the VRods are the same.

you may have to purchase a genuine VW radiator from a VW dealer......cheers.

To find out anything about your bike, you must use the longer frame VIN number. The engine number is an abbreviated version ot the frame number and they should match. This would indicate that the original engine is in the frame. If they do not match, then the engine and frame combination are not as they originally came from the factory. This will destroy any "collector's value" that the bike may have had. You'll have to call Harley's historical division to find the information that you're asking for and since they get so many requests for this, you may not get it.

Good Luck
Steve

That is your vin the frame is your vin it may have a switched power-train but the vin belongs to the frame not engine and transmission.

The vin number commonly known as the frame or chassis number can be found on the front tube of the frame, headstock to the righthand siide at this point the steering yoke is affixed, if this is a uk bike the vin plate should be on the righthand of the frame also,close to your. Right knee when you sit on the bike, but the number on this plate is the same as the one found on the frame, the engine number is located also on the right hand side ontop of the crackcase just above the clutch cover, all of this information can be found on the log book, or registration doc if you have one hope this helps

The frame number is the Vehicle Identification Number. If the engine is the original engine, then the engine is the same year as decoded from the frame number. If it is not the original engine, you are hosed as to determining the year of the engine. The engine numbers will not identify what year the engine is. The only identifier is the frame number. Engine numbers are useless since they only denote the engine size, assembly plant, and sequence of that engine in a production run. You can go to the site below and enter the frame number into the VIN decoder to get the year and other information. Note; back in 1985 the manufacturers adopted 17 digit VIN. If you have less than 17 digits you are out of luck. Please rate my answer. Thanks. http://www.motoverse.com/tools/vin/kawasaki.asp

The Rm125 Vin number is usually on the bikes steering neck, just behind the front Number Board.
Usually it is just to the right of the steering neck so you can read it from the right hand side. The clutch cable will also run close past it so if you follow th eclutch cable from the clutch lever, to where it rounds the frame just past the steering neck, you will see the VIN Number.

There are 2 numbers. One is the frame number or VIN. It is located on the right side of the steering head. The other is engine manufacturers number and is cast in the engine case. Look first on the right side behind the cylinder but anywhere on the crankcase now a days is fair game

Do u mean your vin number or engine number? vin number apears in several places it can be located on dash drivers side in front by windshield or on sticker on door jam or in engine bay located on fire wall. For engine number it is located on block right next to where the block meets the transmission its stamped on msall flat surface there also sometimes under hood on sticker.