2001 Kawasaki KMX 125 how to adjust the power valve

SOURCE: Kawasaki KMX 125 losing power

hi man,
I had a similar problem, so maybe I can help you. it can be connected with air filter. under your seat there should be some kind of cover on the air filter. just remove it. I've noticed this problem when I unrestricted my KMX 125. the hole on the cover on the air filter is too small.

SOURCE: KAWASAKI KMX

ALWAYS have a fire extinguisher on hand when working on carburetors.
Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas then start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Before putting the slide back in the throat of the carb, move the clip on the jet needle one notch lower. Moving the clip will richen the low end fuel mix.Put the rest of the carb back together and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

I hope you will be able to top rate this solution. Thanks!

SOURCE: KMX

need to move the mixture screw in out think about 2 1/2. turns should start u off

SOURCE: putting clutch assembly back together

ge the manual here so you will be able to put the assy back properly

http://www.myxmanuals.com/modules.php?name=Content&pa=showpage&pid=9

SOURCE: i would like to have complete wiring diagram for

http://bikeforum.comxa.com/Forum/motorcycle-owners-manuals/kawasaki-kmx-125-service-manual/

appreciate it if you sign up