To reset the Maintenance Kit Life counter:
1. Press OK to access the Control Panel menus.
2. Select Troubleshooting --> Service Tools.
3. Press the Up Arrow and Down Arrow buttons simultaneously to
access the Hidden Service menu.
4. Select Reset Maintenance Kit to reset the page count and
installation date.
5. Turn printer off, then back on.
6. Test printer operation by printing the Status page.
Your just not meant to.
Fit genuine Xerox parts and have no further problems.
Good Luck.
SOURCE: Maintenance kit for Xerox 8500
Contact the company that you purchased the maintenance kit from.
They should have the solution or send you a replacement.
I know of no way to change the Xerox printer to match up with a non Xerox maintenance kit. They would not set the machine up to accept non Xerox products since that voids warranties.
SOURCE: reset page count
Hi bseema:
Hope that this helps you.
Resetting Fuser Life
This procedure restarts the counter that tracks Fuser life. Perform this procedure after
you install a new Maintenance Kit.
To reset the fuser:
1. From the Main Menu, select Information, then press the OK button.
2. Select Supplies Info, then press the OK button.
3. Select Reset Fuser Life, then press the OK button.
4. Select Reset Fuser Life NOW, then press the OK button to reset the fuser life
SOURCE: XEROX Phaser 8560 - Maintenance Kit
They sell a lot of maintenance kits that way.I worked for a major Tampa are copier company for 10 years and they used every part until it just quit.However, you should line up a maintenance kit at the ready.Sometimes a counter will shut down the copier when it gets to the point where they want it to stop.
SOURCE: RESET INSTRUCTONS FOR XEROX 8560 MAINTENANCE KIT
There is no reset. Xerox never designed a supply reset for this machine.
If you installed a new one, either 1) you've got a bad one (get it replaced under warranty) 2)
the chip is not being read (due to drum maintenance camshaft cracked and out of position
SOURCE: Phaser 8560 warns to replace the maintenance kit
Call Xerox. If they can't reset it, They will sent you a new Mtc kit. Thay will want that count sheet. Plus, They will not warrenty any kits over 6 months.
2,650 views
Usually answered in minutes!
To reset the Maintenance Kit Life counter:
1. Press OK to access the Control Panel menus.
2. Select Troubleshooting --> Service Tools.
3. Press the Up Arrow and Down Arrow buttons simultaneously to
access the Hidden Service menu.
4. Select Reset Maintenance Kit to reset the page count and
installation date.
5. Turn printer off, then back on.
6. Test printer operation by printing the Status page.
×