Alarm cannot be reset with fob key
SOURCE: how to shut off alarm on a 2002 harley davidson heritage soft tai
I long push on the remote turns it on, 2 quick clicks turn it off.
SOURCE: how to reset alarm on heritage softail, bike wont
Set the alarm by holding the key fob button until you see running lights flash twice. Turn off the alarm by pushing the key fob button twice and the lights will flash once.
SOURCE: harley davidson flstc heritage softail 1997
The fork oil is a very specific job needing a manual and a special tool, I don't want to insult anyones mechanical knowledge but if you have never done it before, best to take somewhere else. Engine oil on the other hand is easy, the drain tube to any softail is on the right side by where the frame meets the swing arm, has somekind of plug in it. Start and run bike for a little while, long enough to get it warm but not hot. Remove fill plug and then remove plug in drain line. Using a peice of cardboard or something put in between filter and frame , directing the oil to your drain pan instead of where ever it goes. Put 1 qt oil back in (after everything is reinstalled) start the bike and make sure the oil light goes out, when it does shut bike off and fill to the point that when it is standing upright you get a little oil on the tip of your finger, over filling may result in loss of oil cap from pressure (been there)
SOURCE: I cannot disable the alarm on my 2003 HD Road
service/and transport mode, 1 .with ING off disarm with fob. 2.turn on ING.3. press and hold key fob untill beep.4. turn ING off.5. press and hold till beep.
737 views
Usually answered in minutes!
×