Torquing order specs on cyl head valve cover whats the torque sequence for head and valve cover
SOURCE: Torque setting
Ok, lets see- I still have my old official shop manual for that bike...Cylinder head nut torque is 16-20 ft lbs,Cam sprocket bolt torque is 12-17 ft lbs, Valve adjuster cover torque is 7-10 ft lbs, Cyl head cover torque is (6mm)- 7-10 ft lbs (7mm) 9-12ft lbs, Rocker arm adjuster nut torque is 11-13 ft lbs.
SOURCE: Need cylinder and cylinder head torque specifications 98 XR 250
you dont need torque specs on that just use a 1/2 inch drive with you 14mm or16mm socket hold the wratchet right at the top and tighten it as tight as you could get it like that then use wratchet in normal position and just give it a little snugg it will be perfect i have done it a million time on the same type of bikes...
SOURCE: torque specs for cam on 2006 honda crf250r
Rock the caps around to make sure the bearing locating clips are lined up. Torque the bearing caps to 12 foot-pounds. At this point you must check the valve clearances again. If any are off, the cam must be removed and the correct shims installed.
Please rate this solution. Thanks!
SOURCE: I need 84' Honda xr500 head bolt torque specs.
2.0 - 2.4 kgf m for 6 mm bolt
8 mm bolt 2.6 - 3.0 kgf m
389 views
Usually answered in minutes!
×