Yamaha V-Star 2007 1100 custom carburetor - 2007 Yamaha V Star 1100 Custom

SOURCE: instaling a clutch for a 2001 yamah v star custom

go here for free pdf download service manual

http://www.carlsalter.com/download.asp?fileid=089097109097104097095086083084065082095054053048095077065073078095077065078046112100102

SOURCE: 1999 Yamaha Vstar 650 Custom ...makes clicking noise when trned

i use a jump box on mine most weekends when i wanna take it out, i hook the red to battery and black onto my exhaust and it fires right up no problem. is the clicking noise coming from the fuel pump behind the ignition? it should click for a few seconds then stop. if it stays on then you are not getting enough fuel outta the tank, change the fuel filter and if bike had been stored for winter get a good fuel system cleaner, additive type. if in USA get Berrymans B12, double dose get bike to run hopefully let it stand overnight and all should be fine. fingers crossed. if is is clicking from somewhere else like starter or a relay by the battery, check all the ground terminals you can find
http://www.carlsalter.com/aaman/Yamaha_VSTAR_650_MAIN_MAN.pdf
thats a link for a free pdf service manual
my 99 v star

SOURCE: Is there a free online manual for a 2000 Yamaha

I have found a sight that has all kind of Q&As and has been very heplful. www.sloneservices.com and go to knowledge base. Hope it helps.

SOURCE: 2000 yamaha vstar 1100 custom. starter problem?

I had the same problem 2001 XVS1100 Custom
this is a starter issue Over time the starter on this bike twists when its under a load.
Look at the two bolts holding the starter on if they are not straight across then its twisted. turn starter back in line with a pair of big channel locks and try to start this should do the trick if this works i would recommend taking the two bolts out and bend them back straight or replace and reinstall starter this should fixya problem

Hope this helps ...............Jimmyfixya

SOURCE: 2002 Yamaha Vstar 1100 Custom. STARTER Problem

The starter button is used in an open circuit design.
You must press the starter button to "Close" this circuit before the starter will engage. Taking the starter button out of the loop helps support the suspect short. Assuming you kept the starter button wires from touching. :) If not, it is most likely the starter button.

Trace the wires coming from the starter button.
There could be a short circuit. (Same as pushing the starter button). Check along the handle bars and anywhere rubbing could cause a break in the insulation. Try this at night with the lights off.
You may be able to SEE the spark and locate it quickly.

Good luck!