Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

I have a zx6r 2007 and my f1 light is on,the bike starts but as soon as I try to put it in gear it cuts out

As soon as I try to put the bike into gear it cuts out

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 39 Answers

O2 sensor in muffler system not registering CPU shut down

Posted on May 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
rockitman187
  • 2559 Answers

SOURCE: my dt125 starts but when i put it in gear it cuts out

SOUNDS LIKE IT COULD BE THE SAFETY SWITCH FOR THE KICK STAND ,IF THE SWITCH HAS BEEN DAMAGED IT WILL START UP FINE AND WHEN PUT IN TO GEAR AND CLUTCH IS RELEASED IT WILL DIE.(This is a safety feature)

If that don't fix,Please post back

Please rate this fixya solution

Posted on Jan 23, 2009

  • 51 Answers

SOURCE: Bike shuts off when in gear

hello and welcome
it seems that you may have a faulty side stand switch. the side stand needs to be in the up position before the bike can be started off in gear. but if not the side stand contains a saftety switch that shuts the bike off when put into gear. to verify this you can check for spark when the bike is being turned over in gear with the clutch held in.
there should be two wires associated with this switch. a green, and green with white. so when the stand is up these two wires are connected, and the switch can be tested as such. thank you.

Posted on Mar 22, 2009

  • 1392 Answers

SOURCE: suzuki sv1000s , f1 light came on and the bike doesn't start

Sounds like you have a problem with the computer or the FI system on the bike. That is what the (F)uel (I)njection is on for.

Posted on Aug 16, 2009

  • 11 Answers

SOURCE: motor cuts out when gear engaged

Make sure you have your stand up before you put it in gear. Some bikes have a stand switch that doesnt allow the bike to be in gear while the stand is down. This switch may have been damaged when the bike fell and now be malfunctioning.

Posted on Sep 27, 2009

Testimonial: "THANK YOU MR BEETHAM!!Ignorance can be bliss but it can also be bloody annoying!You have saved me from a sleepless night-so simple,will never forget!"

  • 47 Answers

SOURCE: its flashing f1 what does that mean on my kawasaki

the flashing " f i " light on the spedo is the "fuel injection" on-board diagnostic system light, suggestion: check under the seat there is a yellow wire coming out of the ECU that is touhed to chasis ground in order to retreve the trouble codes, the wire may be pinched and contacting ground, causing the light to flash codes.

Posted on Dec 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Kawasaki zx6r 2009 keeps displaying f1 and with a flashing red light. The bike runs fine. Sometimes shuts off while warming up. how do I fix it?


it actually means fault indicator and doesn't deal solely with the fuel injection.

put the key in the ignition and turn it on, but don't start the bike. use the mode button to go to the odometer display, then hold the mode button down for 2 seconds. the code should be displayed.

come back when you have the code

Apr 18, 2015 | kawasaki Motorcycles

1 Answer

Bike cutting out


Do you have the kickstand up when you put it in gear? Many bikes have a lockout on the side stand to prevent you riding away with the stand down. Kills the engine instantly when placed in gear with the stand down.

Jul 21, 2014 | 1998 Honda XLR 125 R

1 Answer

I have a 2007 zx6r and it runs fine but the f1 light is flashing but as soon as you try to put it in gear it cuts out


Hi. There ae numerous forums/site for your bike's FI codes. Since I don't know what code your FI is flashing, all I can say is put the FI code into your computer google or yahoo search area, and you will get an answer. Yiur FI should flash a few times first, and that is the first digit in the sequence. A second later, it should flash again, and that is th 2nd digit in the code. an EXAMPLE is 2 flashes, pause, 3 flashes...then repeats. That will be a code 23. Trust me, you will find the FI code online. Good luck!

Apr 06, 2014 | 2004 Honda CBR 125 R

1 Answer

F1 light flashing on my zx6r 2007


Have you replaced your exhurst system if you have did you put the O2 sensor back in as f1 error code is for this sensor and your CPU can not tell if the engine is running correctly and will shut the engine down when a gear is selected

Apr 06, 2014 | kawasaki ZX-6R Ninja Motorcycles

1 Answer

2007 Kawasaki Ninja ZX6R FI light flashing


Hi, Dean it should be noted that the reasons your FI light stays on constantly or flashes and your bike will or will not start and may turn over or may not and run great or sputter, these conditions will vary from bike to bike depending on the year, make, and model and you should always refer to your owners/service manual for proper diagnostic procedures. It should also be noted that any type of prior work done to the bike or an abnormal event occurrence IE: adding accessories, electrical curiosity/adventures, laying the bike down/crashes, rain storms/bike washings just before FI light issues started can be significant hints/aids into tracking down the gremlin, also carry the appropriate jumper wire to access fault codes to reduce the risk of being stranded or towed. The newer the bike the more sensitive the ECM becomes and will not let the bike start when aftermarket accessories have been installed without being reprogrammed. That being said the usual suspects are:
1. Faulty Fuel Pump, fuse or system relay switch.
2. Battery starting to fail due to old age/damage, perform a load test.
3. A discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Faulty safety switches/sensors: run/off, ignition, clutch lever, neutral, side stand, tip over, fuel, and or their connections.
5. Broken wire or worn insulation exposing wire to a ground situation especially inside wire harness at tight bends around fairing brackets, under dash panels, under fuel tanks over cylinder heads etc. Many harnesses are open on the ends that will allow water to enter and accumulate at v-bends.
Dielectric grease and contact cleaner are your best friends for wire/cable/harness connectors, look for corroded, broken, or loose pins/sockets.
6. Installation of aftermarket accessories ie. exhaust systems, mufflers, air cleaners, fuel tuners, electrical component etc.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.zx6r.com/zx6r/28047-fi-light-flashing-wont-start-help-please.html
07 ZX6R fi red light 001 HELP
Kawasaki Ninja ZX 6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual

Sep 17, 2012 | 2007 kawasaki Ninja ZX6R

1 Answer

Hi!!!!! i have an kawasaki zx6r 1998 and it dosent want to start , i started it 2 days ago, but today it dosent want i charged battery, and when i push start button it dosent do nothing, i checked coil...


Check the clutch, neutral and side stand safety interlocks.
Double check that the bike is in neutral, and the clutch is pulled in when trying to start the bike.
If the bike is in gear with the side stand down, the bike cuts off all ignition.
If the clutch isn't pulled in, the starter won't engage.
Check all these safety interlock switches, and make sure you are in neutral with the clutch in when trying to start the bike.

Jun 27, 2011 | kawasaki ZX-6R Motorcycles

1 Answer

Kawasaki Kit ECU on '07 ZX-6R race bike


Hi, Simon_mcaule the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable race shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. Not being able to pull codes really puts you in the dark, could be a faulty connection in the ignition circuit or you may have a temperamental ECM that doesn't like aftermarket performance parts, a face to face with your fuel tuner may also be in order.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2009 ZX6R Engine Dies randomly intermittently Help please
06 zx6r randomly shuts off
http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%202007%20Service%20Manual.pdf
OEM Parts for Kawasaki
http://www.factorypro.com/manuals/Kaw,KRT,zx6r,zx10r,05-07,Mk2,lateKRT/zx6r,07,Racing_Kit_Manual.pdf
Kawasaki Ninja ZX 6R Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Jul 13, 2017 | 2007 kawasaki ZX-6R

2 Answers

F1 light comes on bike cuts off of my 2008 gsx . i change oil -gas- and bought it to the shop and the same problem. when i turn the bike on i runs for a little while then turns off


F-I is fuel injection system telling you to clean air-filter,fuel-filter and clean the fuel injector system. This is a good start.

Apr 11, 2010 | 2007 Suzuki GSX-R 750

3 Answers

Bike runs ticks over in neutral soon as iput in gear cuts out


hi...put kickstand up 1st befor putting in gear....as this how bigger hondas work its a safety thing so u carnt ride off with side stand down...but cuts engine if kickstand still down & then wont start as you in gear.....even if kickstand up wont start in gear!!...hope this helps

Jan 26, 2010 | Honda XL 125 R Motorcycles

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5944 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

ROB

Level 3 Expert

858 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...