Need to remove front wheel to replace tire
SOURCE: Front Wheel Bearing Shot - Please help!
I might have the right size internal bearing puller at work. It looks a little like this... but uses a threaded bolt instead of a slide hamer.
SOURCE: can not remove axle cover,
Hi, easy fix you have to pry the cover off. you can use a screw driver, or a pry bar.
SOURCE: remove front wheel 1990 zzr1100
Hi ...... You need to support the bike level (front paddock stand) and undo one side pinch bolt then using the hex adapter for that side unscrew anticlockwise ..................... I cant remember whether it's a 15mm or 17mm. The front spindle is threaded both sides. Support wheel & pull spindle out. Assembly is reverse but you have to make sure speedo drive is engaged correctly prior to tightening up.
SOURCE: Instructions for removing/replacing rear wheel, 2007 FLHR
remove the bags and side covers /remove clip from rh side of axel remove nut/put wrench on lh side of axel and twist to loosen belt adjustment caution !! note clamshell adjusters both sides they need to go back the same way when refiting wheel knock the axel from rh side through with large screw driver use hand not hammer the wheel should drop stand over back fender lift wheel slightly slip off belt roll brake caliper up and outwards untill it clears drop wheel down and remove brake caution again!! belt tension should be 10lbs 4.5 kg force centre from front and rear sprocket you will need belt tension tool for correct tension
SOURCE: Left-front wheel bearing is worn-out
the wheel bearing will need to be pressed on so unless you know someone to press it for you you might want to take it to a shop.
262 views
Usually answered in minutes!
×