Looking for a complete repair manual for my vt250f

come back with what engine you have as cummins and detroit have manuals to cover this topic

Unless you have coolant in the oil, there is no real reason you'd want to remove the engine. Yes, after it's removed it's easier to replace the head(s) but any time saved there is wasted during the time spent taking it out of the vehicle. Most larger parts stores sell vehicle specific manuals, Most are under $30. Buy one when you get the new parts and use it as a guide fro R&R. Best to use tape labels and take photos as you work so you can find and put everything back correctly.

Hi, I have Honda VT250 1985, Honda service manual (for 82-86 VT250F) states that it needs 2.5L of engine oil is required.

It is a fairly involved job. You will need to remove the intake & exhaust manifold. The head then must be removed and cleaned. Take the head to a machine shop and have it inspected for warpage. Unless you are really handy I suggest you have this done by a pro. A Chilton's or Hayne's Repair Manual for your Suzuki will be of immense help if you decide to tackle it.

I would recommend the MITCHELL'S Online Manuals. Go to www.mitchell.1.com and you can get a single subscription for about $10. When I had my own repiar shop I had te complete set of Mitchell's. Very complete and just a good as the factory repair manuals (maybe better). I especially liked the wiring diagrams. Very complete.
Good Luck. . . . . BTW, you SHOULD replace the head bolts regardless of which type of gasket you use. Once they are torqued, they shouldn't be used again.

trying to remove rear shocks took off side and rear baggage do I need to remove the rear assembly to take shocks off

# Properly relieve the fuel system pressure.

# Drain the cooling system.

# Remove or disconnect the following:

Negative battery cable

Brake booster vacuum hose from the dynamic chamber

Fuel line from the pressure regulator and the return line from the rear of the dynamic chamber

Ground wire from the intake manifold

Purge solenoid valve vacuum hose

Upper radiator hose

Intake manifold support bracket

Converter flange inlet pipe

Timing belt

Cylinder head cover

Cylinder head with the intake and exhaust manifolds attached

3 wire harness connectors at the rear of the cylinder head

Try here...
http://www.tar.hu/vt/manual_en.htm

If no good.... then I can email it to you direct...