Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

Conecting a new battery to a Ninja 600

Sequence of connecting the battery

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 260 Answers

Connect the earth first then the power side.

Posted on Mar 17, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to find out how to put wiring on


Kawasaki Motorcycle Wiring Diagrams

www.classiccycles.org/1852/597943.html
Kawasaki BN125 Eliminator 125 Electrical Wiring Harness Diagram Schematic HERE... Kawasaki GPX600 Ninja GPX 600 Electrical Wiring Harness Diagram ...Missing: tpgs

Kawasaki Motorcycle Service Manuals

www.classiccycles.org/1852/1894.html
Kawasaki BN125 Eliminator BN 125 Workshop Service Repair Manual HERE ...Kawasaki GPX600 Ninja 600 Electrical Wiring Diagram Schematic 1988 to 1991 ...Missing: tpgs

WIRING DIAGRAM thread for all sorts of bikes - Bike Chat Forums

www.bikechatforums.com/viewtopic.php?p=2322761

Oct 11, 2009 - 25 posts - ‎7 authors
this is the new wiring diagram thread, requests allowed .... http://i574.photobucket.com/albums/ss182/hmmmnz1/Honda/th_cb600f.jpgCB600f ...Missing: tpgs

Jan 27, 2016 | Motorcycles

1 Answer

Changed the battery now it wont start


make sure the battery is connected correctly, charged ,and it gets a good conection. some times new batteries need to be charged.

Mar 03, 2013 | 2003 Honda VT 600 C Shadow

2 Answers

No power to key switch;


try to see if any wire is making a short-circuit since it have a crash ligth it maybe reach the wires if not see any fuse or wire plugs if they are all connect.

May 05, 2012 | Motorcycles

1 Answer

99 kawasaki ninja EX250 motor swap for a 98 NINJA EX250 MOTOR


I would try charging the battery. Take it off and put it on a slow trickle charge overnight. Batteries usually only last 3-4 years if it is an acid battery.

Nov 27, 2011 | kawasaki Kawasaki Ex250f11 Ninja 250r...

1 Answer

Where do you conect the speedo on fzr 600 91 Is


it should be a cable.....goes from the front wheel to a connection in the gauge cluster left side if ur sitting on the bike ( easy fix not many if any tools needed)

Oct 16, 2010 | 1991 Yamaha FZR 600

1 Answer

1986 Kawasaki Ninja 600 problems will not idle after a few minutes


Hi, Hardrider40 and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Faulty or corroded kill switch.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked, loosen gas cap and go for a test ride.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Petcock clogged or damaged.
20. Lean angle switch is faulty or needs adjustment.
21. Catastrophic engine failure, perform a compression test.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.visordown.com/forum/workshop/idle-problems-with-my-gpz600r
92 Ninja 600 bogs down and won idle after few minutes of riding
Kawasaki 1985 ZX600 Service And Repair Manual
OEM Parts for Kawasaki
http://mybikemanuals.com/kawasaki

Mar 05, 2010 | 1991 kawasaki ZZR 600

1 Answer

Brake light does not always work with front brake - Ninja 250


Check the wiring connections to the front brake switch. If all OK, then it could be the switch.

Jun 25, 2009 | 1992 Suzuki GSX 600 F (Katana)

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5873 Answers

Marvin
Marvin

Level 3 Expert

84966 Answers

richard libby

Level 2 Expert

208 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...