I am the owner of a 1993 BMW R1100 RS motorcycle with about 50000 miles on the clock. I will be riding at a steady speed,when i see on the rev counter she just cut out and come back to live again.
SOURCE: Rev counter jumps when idling and then engine cuts out
sounds like the idle speed sensor,if your rpm's are idling up and down
SOURCE: Rev counter jumps whilst idling and then engine cuts out
Your problem sounds as if the thermo sensor....which controls the air
fuel ratio when engine is cold....is faulty. It is a common fault on
this model.
This is not an expensive part, and takes only a short time to fit.
Good luck
John
SOURCE: kawasaki gpz 1000 rx 1987 model
Running well at high revs would indicate that all the fuel and air it needs are getting to the engine and you also have a good spark. Probably no problem with air and fuel filter ( if fitted) or sparkplugs.
Running hot, and bad idling are signs of a lean air fuel mixture. The engine is probably not getting enough fuel at low revs.
This could be caused by an air leak between the carburettors and the engine. Check that the vacuum line to the fuel tap is properly secured at both ends. It is behind the fuel line at the tap.
Get a a short length of hollow plastic tube and use it like a stethascope - put one end to your ear and move the other end around your carburettor mounts with your engine revs as low as you can get, and listen for any sucking noises that would indicate a leak. Look for cracks in the rubber inlets.
The other possibility is that there is an internal blockage in the idling jets or idling fuel circuit. This is where dirt tends to lodge because the jet dimensions and passageways are very fine - The high speed jets are much bigger and dirt often just passes straight through.
Try a little bit of choke while the engine is warm to see if you get a stronger low speed response. If so that would point to an internal blockage.
SOURCE: I HAVE AN OLD YAMAHA SR 125 ITS REVS GO UP AND
Remove the water trap bowl at the bottom of the petcock, (gas valve). Any water or trash in the bowl? Drain a cup of gas from the tank. Any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).
Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the two screws on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. Set the idle speed with the idle screw. This process should get you back on the road.
Since you mentioned uneven idle revs, be sure the carb and manifold are on tight and also tighten the cylinder and head. Air leaks can screw up the idle.
Please rate this solution. Thanks speedfreak41
SOURCE: motorcycle dies while riding,like gas is cut off
Most likely your high speed needle valve seat has dirt in it. Try removeing the bowl and cleaning the Main Jet.
179 views
Usually answered in minutes!
×